Supermicro CSE-809T-1200B Manual de usuario descargar pdf (Pagina 20)

SC809 Chassis Manual

4-2

4-2 Control Panel Buttons

There are two push-buttons located on the front of the chassis. These are (in order

from left to right) a reset button and a power on/off button.

Reset: The reset button is used to reboot the system.•

Power: The main power switch is used to apply or remove power from the power •

supply to the server system. Turning off system power with this button removes

the main power but keeps standby power supplied to the system. Therefore,

you must unplug system before servicing.

4-3 Control Panel LEDs

The control panel located on the front of the SC809 chassis has ve LEDs. These

LEDs provide you with critical information related to different parts of the system.

This section explains what each LED indicates when illuminated and any corrective

action you may need to take.

Overheat/Fan Fail: When this LED ashes it indicates a fan failure. When •

continuously on (not ashing) it indicates an overheat condition, which may be

caused by cables obstructing the airow in the system or the ambient room

temperature being too warm. Check the routing of the cables and make sure all

fans are present and operating normally. You should also check to make sure

that the chassis covers are installed. Finally, verify that the heatsinks are installed

properly. This LED will remain ashing or on as long as the temperature is too

high or a fan does not work correctly.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 59 60

Sin comentarios

Supermicro CSE-809T-1200B Manual de usuario Pagina 20