Supermicro AOC-STG-I2T Guía de usuario descargar pdf (Pagina 18)

3-4

AOC-STG-i2T Add-on Card User's Guide

3-6 Building the Driver Manually

Follow the instructions below to build the driver manually.

1. Move the base driver tar le to the directory of your choice. For example,

/home/username/ixgbe

/usr/local/src/ixgbe.

2. Untar/unzip archive:

tar zxf ixgbe-x.x.x.tar.gz

3. Change to the driver src directory:

cd ixgbe-x.x.x/src/

4. Compile the driver module:

make install

The binary will be installed as:

/lib/modules/[KERNEL_VERSION]/kernel/drivers/net/ixgbe/ixgbe.[k]o

The install locations listed above are the default locations. They might not be

correct for certain Linux distributions. For more information, see the ldistrib.txt

le included in the driver tar.

Note: IXGBE_NO_LRO is a compile time ag. The user can enable it at

compile time to remove support for LRO from the driver. The ag is used

by adding CFLAGS_EXTRA=-”DIXGBE_NO_LRO” to the make le when

it’s being compiled.

make CFLAGS_EXTRA=”-DIXGBE_NO_LRO” install

5. Load the module:

For kernel 2.6.x, use the modprobe command:

modprobe ixgbe <parameter>=<value>

For 2.6 kernels, the insmod command can be used if the full path to the driver

module is specied. For example:

insmod /lib/modules/<KERNEL VERSION>/kernel/drivers/net/ixgbe/ixgbe.ko

1 2 ... 13 14 15 16 17 18 19 20 21

Sin comentarios

Supermicro AOC-STG-I2T Guía de usuario Pagina 18