Supermicro AOC-USASLP-L8I Manual de usuario descargar pdf (Pagina 20)

AOC-USASLP-L8i Add-on Card User’s Manual

4-2

The number of physical drives in a specific array determines the possible RAID levels

that you can implement with the array. See Section 2-3: "RAID Minimum Drive

Requirements" on page 2-3 for further details.

Starting the MegaRAID BIOS CU

Follow these steps to start the MegaRAID BIOS CU:

1. During boot-up, wait for the following message to appear on the screen:

Press Ctrl-M to run LSI Software RAID Setup Utility

2. When you see this message, hold down the C

TRL key while pressing the M-KEY.

The RAID CONFIGURATION UTILITY MANAGEMENT MENU screen appears, as shown in

Figure 4-1.

Using Easy Configuration

When you select the Easy Configuration Option, the CU creates one or more arrays

from the available physical drives and configures each array as a single virtual drive. If

virtual drives have already been configured, the CU does not change their configuration.

Figure 4-1. RAID Configuration Utility Management Menu Screen

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 103 104

Sin comentarios

Supermicro AOC-USASLP-L8I Manual de usuario Pagina 20