Supermicro 2026TT-H6RF Manual de usuario descargar pdf (Pagina 43)

Chapter 5: Advanced Serverboard Setup

5-7

5-4 Installing Memory

Memory Support

The X8DTT-H series serverboard supports up to 96 GB of Registered ECC or

24 GB of Unbuffered ECC/Non-ECC DDR3 1333 MHz/1066 MHz/800 MHz in 12

DIMM slots (max. of 8 GB of Registered ECC and 2 GB of Unbuffered memory

per DIMM slot.).

Note: Check the Supermicro web site for recommended DIMMs.

Installing Memory Modules

Insert each memory module vertically into a slot following the charts below. 1.

Pay attention to the notch along the bottom of the module to prevent inserting

it incorrectly.

Gently2. press down on the DIMM until it snaps into place in the slot (see

Figure 5-2).

Repeat for all DIMMs. See tables below and on following pages.3.

CAUTION! Exercise extreme care when installing or removing DIMM

modules to prevent any possible damage.

Populating Memory for Optimal Performance

(Single CPU Conﬁ guration)

Branch 0 Branch 1 Branch 2

3 DIMMs P1 DIMM1A P1 DIMM2A P1 DIMM3A

6 DIMMs P1 DIMM1A P1 DIMM1B P1 DIMM2A P1 DIMM2B P1 DIMM3A P1 DIMM3B

Populating Memory for Optimal Performance

(Dual CPU Conﬁ guration)

CPU1 CPU2

Branch 0 Branch 1 Branch 3 Branch 0 Branch 1 Branch 3

6 DIMMs 1A 2A 3A 1A 2A 3A

DIMMs

1A 1B 2A 2B 3A 3B 1A 1B 2A 2B 3A 3B

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 105 106

Sin comentarios

Supermicro 2026TT-H6RF Manual de usuario Pagina 43