Supermicro SuperServer 7046T-3R Manual de usuario descargar pdf (Pagina 10)

1-2

SUPERSERVER 7046T-3R User's Manual

1-2 Serverboard Features

At the heart of the SuperServer 7046T-3R lies the X8DT3, a dual processor

serverboard based on the Intel IOH-36D + ICH10R chipset and designed to provide

maximum performance. Below are the main features of the X8DT3. (See Figure 1-1

for a block diagram of the chipset).

Processors

The X8DT3 supports single or dual Intel® Xeon 5500 Series processors and future

Intel Nehalem processor families (next generation Intel Xeon® processor). Please

refer to the serverboard description pages on our web site for a complete listing of

supported processors (www.supermicro.com).

Memory

The X8DT3 has twelve 240-pin DIMM slots that can support up to 96 GB of DDR3-

1333/1066/800 registered ECC SDRAM. The memory operates in an interleaved

conﬁ guration and requires requires modules of the same size and speed to be

installed two at a time. See Chapter 5 for details.

Onboard SAS

An onboard LSI 1068E SAS controller in integrated into the X8DT3 for an 8-port SAS

subsystem. The hot-swap SAS drives are connected to a backplane that provides

power, bus termination and conﬁ guration settings.

Note: The operating system you use must have RAID support to enable the hot-

swap capability and RAID function of the SAS drives. RAID 0, 1, 5 and 10 are sup-

ported. Refer to the following ftp site for setup guidelines <ftp://ftp.supermicro.com/

driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pdf> and Supermicro's web site for

additional inmformation < http://www.supermicro.com/support/manuals/>.

Serial ATA

A Serial ATA controller is integrated into the ICH10R (South Bridge) portion of the

IOH-36D chipset to provide a six-port 3 Gb/s SATA subsystem, which is RAID 0, 1,

10 and 5 supported. The SATA drives are hot-swappable units.

Note: The operating system you use must have RAID support to enable the hot-

swap capability and RAID function of the SATA drives. RAID 5 requires the use

of an iButton.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 105 106

Sin comentarios

Supermicro SuperServer 7046T-3R Manual de usuario Pagina 10