Supermicro SYS-7045A-WTB Ficha de datos descargar pdf (Pagina 66)

6-6

uperWorkstation 7045A-WT User's Manual

Installing/Removing SATA Drives

The SATA drive carriers are all easily accessible at the front of the chassis. These

drives are hot-swappable, meaning they can be removed and installed without

powering down the system.

Open the front bezel then push the release button located beside the drive

LEDs.

Swing the handle fully out and then use it to pull the unit straight out.

Note: Your operating system must have RAID support to enable the hot-swap

capability of the SATA drives.

Mounting a SATA drive in a Drive Carrier

The SATA drive carriers help to promote proper airﬂ ow for the system. For this

reason, even carriers without SATA drives must remain in the server.

Insert the drive into the carrier with the printed circuit board side facing down

so that the mounting holes align with those in the carrier.

Secure the drive to the carrier with four screws (see Figure 6-5).

6-4 Drive Bay Installation

A total of six SATA drives may be housed in the SC743SQ-865 chassis. The drive

IDs are preconﬁ gured as 0 through 5 in order from bottom to top (or from left to

right if rackmounted).

A bezel covers the drive area but does not need to be removed to access the drives;

simply swing open the bezel. If you wish to remove the bezel piece, push on the

three tabs on the inside of the left lip of the front chassis cover. Then slightly swing

out the same (left) side of the cover - about ½ inch only. Remove by pushing on

the open side of the cover to remove it from the chassis (do not try to swing or pull

it straight out after opening the left side).

Regardless of how many SATA drives are installed, all drive carriers

must remain in the drive bays to promote proper airﬂ ow.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 143 144

Sin comentarios

Supermicro SYS-7045A-WTB Ficha de datos Pagina 66