Supermicro SYS-7046T-H6R Manual de usuario descargar pdf (Pagina 62)

6-6

SUPERSERVER 7046T-H6R/7046T-H6RF User's Manual

Installing/Removing SAS/SATA Drives

To remove a carrier, ﬁ rst open the front bezel.1.

Push the release button located beside the drive LEDs (See Figure 6-5).2.

Swing the handle fully out and then use it to pull the unit straight out.3.

Note: Your operating system must have RAID support to enable the hot-swap

capability of the drives.

Mounting a SAS/SATA Drive in a Drive Carrier

Insert the drive into the carrier with the printed circuit board side facing down 1.

so that the mounting holes align with those in the carrier.

Secure the drive to the carrier with four screws (see Figure 6-6).2.

6-4 Drive Bay Installation

SAS Drives

A total of eight SATA drives may be housed in the SC745TQ-R800B chassis. The

drive IDs are preconﬁ gured as 0 through 7 in order from bottom to top (or from left

to right if rackmounted). A bezel covers the drive area but does not need to be re-

moved to access the drives; simply swing open the bezel. If you wish to remove the

bezel piece, push on the three tabs on the inside of the left lip of the front chassis

cover. Then slightly swing out the same (left) side of the cover - about ½ inch only.

Remove by pushing on the open side of the cover to remove it from the chassis (do

not try to swing or pull it straight out after opening the left side).

The SAS drives are mounted in drive carriers to simplify their installation and

removal from the chassis. These drives are hot-swappable, meaning they can be

removed and installed without powering down the system. The carriers also work

to promote proper airﬂ ow for the system. For this reason, even carriers without

SAS drives must remain in the server.

Regardless of how many SAS drives are installed, all drive carri-

ers must remain in the drive bays to promote proper airﬂ ow.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 101 102

Sin comentarios

Supermicro SYS-7046T-H6R Manual de usuario Pagina 62