Supermicro 1012C-MRF Manual de usuario descargar pdf (Pagina 38)

5-6

A+ Server 1012C-MRF User's Manual

5-4 Installing Memory

CAUTION! Exercise extreme care when installing or removing DIMM

modules to prevent any possible damage.

Memory Support

The H8SCM-F serverboard supports single/dual/tri/quad-channel, DDR3 Registered

DDR3-1333/1066/800 or DDR3 Unbuffered ECC/non-ECC SDRAM. Only

interleaved memory is supported, so you must populate four DIMM slots at a time

(see procedure above).

Populating four adjacent slots at a time with memory modules of the same size and

type will result in interleaved (128-bit) memory, which is faster than non-interleaved

(64-bit) memory.

Note: Check the Supermicro web site for recommended DIMMs.

Installing Memory Modules

Insert each memory module vertically into its slot, paying attention to the 1.

notch along the bottom of the module to prevent inserting the module

incorrectly (see Figure 5-4).

Install to slots CPU1/DIMM1A, CPU1/DIMM2A, CPU1/DIMM3A and CPU1/2.

DIMM4A, etc. Always install in groups of four and in the numerical order of

the DIMM slots. See support information below.

Gently press down on the memory module until it snaps into place.3.

With four CPUs installed, repeat step 2 to populate the CPU2 DIMM slots. 4.

Always install four DIMMs to both CPU DIMM slots for more efﬁ cient

operation.

Note: 1 GB, 2 GB, 4 GB, 8 GB and 16 GB memory modules are supported. It

is highly recommended that you remove the power cord from the system before

installing or changing memory modules. Please refer to our web site for memory

that has been tested on the H8SCM-F serverboard.

Maximum Memory

Maximum memory for the H8SCM-F serverboard is up to

16GB of ECC/Non-ECC UDIMM or up to 64GB of ECC RDIMM.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 91 92

Sin comentarios

Supermicro 1012C-MRF Manual de usuario Pagina 38