Supermicro 5017C-TF Manual de usuario descargar pdf (Pagina 18)

2-4

SUPERSERVER 5017C-TF User's Manual

Figure 2-1. Identifying the Sections of the Rack Rails

2-4 Installing the System into a Rack

This section provides information on installing the SuperServer 5017C-TF into a

rack. If the system has already been mounted into a rack, you can skip ahead to

Sections 2-5 and 2-6.

There are a variety of rack units on the market, which may mean the assembly

procedure will differ slightly. The following is a guideline for installing the unit into

a rack with the rack rails provided with the system. You should also refer to the

installation instructions that came with the rack unit you are using.

Identifying the Sections of the Rack Rails

You should have received two rack rail assemblies with the SuperServer 5017C-

TF. Each of these assemblies consist of two sections: an inner ﬁ xed chassis rail

that secures to the unit (A) and an outer ﬁ xed rack rail (B) that secures to the rail

brackets. A sliding rail guide sandwiched between the two should remain attached

to the ﬁ xed rack rail (see Figure 2-1). The A and B rails must be detached from

each other to install.

To remove the ﬁ xed chassis rail (A), pull it out as far as possible - you should hear

a "click" sound as a locking tab emerges from inside the rail assembly and locks

the inner rail. Then depress the locking tab to pull the inner rail completely out. Do

this for both the left and right side rack rail assemblies.

Pull out the inner

rail(to be attached

on the chassis)

Outer rail (to be

installed in the

rack)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 93 94

Sin comentarios

Supermicro 5017C-TF Manual de usuario Pagina 18