Supermicro 5017C-TF Manual de usuario descargar pdf (Pagina 23)

Chapter 2: Server Installation

2-9

2-6 Checking the Drive Bay Setup

Next, you should check to make sure the peripheral drives and the SATA drives have

been properly installed and all essential connections have been made.

Checking the Drives

For servicing the DVD-ROM and ﬂ oppy drives, you will need to remove the top

•

chassis cover.

The Serial ATA disk drives can be installed and removed from the front of the •

chassis without removing the top chassis cover.

Depending upon your system's conﬁ guration, your system may have one or •

two Serial ATA drives already installed. If you need to install Serial ATA drives,

please refer to the appropriate section in Chapter 6.

Checking the Airﬂ ow

Airﬂ ow is provided by two 10-cm input fans. The system component layout was •

carefully designed to promote sufﬁ cient airﬂ ow through the small 1U rackmount

space.

Also note that all power and data cables have been routed in such a way that •

they do not block the airﬂ ow generated by the fans.

Providing Power

The last thing you must do is to provide input power to the system. Plug the •

power cord from the power supply unit into a high-quality power strip that offers

protection from electrical noise and power surges.

It is recommended that you use an uninterruptible power supply (UPS). •

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 93 94

Sin comentarios

Supermicro 5017C-TF Manual de usuario Pagina 23