Supermicro SuperServer 6028R-TRT Manual de usuario descargar pdf (Pagina 79)

Chapter 6: Advanced Chassis Setup

6-5

SATA Drive Installation

These drives are mounted in carriers to simplify their installation and removal from

the chassis. The carriers also help promote proper airow for the drives. For this

reason, even empty carriers without hard drives installed must remain in the chassis.

Removing a Drive Carrier

1. Push the release button located beside the drive's LEDs.

2. Swing the handle fully out and use it to pull the drive carrier straight out (see

Figure 6-3).

Mounting a Drive in a Drive Carrier

1. To add a new SATA drive, install the drive into the carrier with the printed

circuit board side facing down so that the mounting holes align with those in

the carrier.

2. Secure the drive to the carrier with four screws, as shown in Figure 6-4.

Note: Your operating system must have RAID support to enable the hot-plug ca-

pability of the drives.

Figure 6-3. Removing a Drive Carrier

Release Button

Handle

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 125 126

Sin comentarios

Supermicro SuperServer 6028R-TRT Manual de usuario Pagina 79