Supermicro SuperStorage Server 2027R-E1R24L Manual de usuario Pagina 68
- Pagina / 131
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 5: Advanced Serverboard Setup
5-19
Overheat/Fan Fail/PWR Fail LED
Connect an LED to the OH connection
on pins 7 and 8 of JF1 for the Over-
heat/Fan Fail/Power Fail and UID
LED connections. The red LED on
pin 7 provides warning of overheat,
fan failure or power failure. The blue
LED on pin 8 works as the front panel
UID LED indicator. The red LED takes
precedence over the blue LED by
default. Refer to the table on the right
for pin defi nitions.
HDD LED
The HDD LED connection is located
on pins 13 and 14 of JF1. This LED
is used to display all IDE/SAS/SATA
activity. See the table on the right for
pin defi nitions.
OH/Fan Fail LED
Pin Defi nitions (JF1)
Pin# Defi nition
7 Vcc
8 Ground
NIC2 LED
Pin Defi nitions (JF1)
Pin# Defi nition
9 Vcc
10 Ground
HDD LED
Pin Defi nitions (JF1)
Pin# Defi nition
13 Vcc
14 HD Active
NIC2 (JLAN2) LED
The LED connections for JLAN2 are
on pins 9 and 10 of JF1. Attach an
LED cable to display network activ-
ity. See the table on the right for pin
defi nitions.
NIC1 LED
Pin Defi nitions (JF1)
Pin# Defi nition
11 Vcc
12 Ground
NIC1 (JLAN1) LED
The LED connections for JLAN1 are
on pins 11 and 12 of JF1. Attach an
LED cable to display network activ-
ity. See the table on the right for pin
defi nitions.
OH/Fan Fail Indicator
Status
State Defi nition
Off Normal
On Overheat
Flash-
ing
Fan Fail
Power Fail LED
The Power Fail LED connection is
located on pins 5 and 6 of JF1. Re-
fer to the table on the right for pin
defi nitions.
PWR Fail LED
Pin Defi nitions (JF1)
Pin# Defi nition
5 Vcc
6 Ground
- SUPER 1
- Manual Revision 1.0 2
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 3 System Interface 7
- Chapter 7 BIOS 8
- Chapter 1 10
- Introduction 10
- 1-2 Serverboard Features 11
- 1-3 Server Chassis Features 12
- System Block Diagram 13
- X9DRD-7(J)LN4F 14
- 1-4 Contacting Supermicro 15
- Chapter 2 16
- Server Installation 16
- Warnings and Precautions! 17
- Rack Mounting Considerations 18
- Inner Rails 21
- Standard Chassis Installation 23
- Chapter 3 26
- System Interface 26
- Power Fail 27
- Overheat/Fan Fail 27
- 3-4 Drive Carrier LEDs 28
- Chapter 4 30
- ﺔﻴﺋﺎﺑﺮﻬﻜﻟﺍ 32
- Installation Instructions 33
- 250 V, 20 A 34
- Power Disconnection Warning 35
- ילמשח קותינ ינפמ הרהזא 36
- Equipment Installation 37
- Restricted Area 38
- Battery Handling 39
- Redundant Power Supplies 41
- Backplane Voltage 42
- Product Disposal 44
- רצומה קוליס 45
- Power Cable and AC Adapter 47
- (UL/CSA ﻞﻤﺤﺗ ﻲﺘﻟﺍﺔﻣﻼﻋ ) 48
- Chapter 5 50
- Advanced Serverboard Setup 50
- • Control Panel cable (JF1) 51
- 2 1 52
- 20 19 52
- OPEN 1st 53
- WARNING! 53
- 5-5 Installing Memory 58
- DIMM Module Population Tables 59
- 1 CPU, 2 DIMMs 61
- 1 CPU, 5-8 DIMMs 61
- 1 CPU, 4 DIMMs 61
- Rev. 1.01 62
- 5-6 Adding PCI Add-On Cards 63
- 5-7 Serverboard Details 64
- LED Description State 66
- 5-8 Connector Defi nitions 67
- BMC Enable 74
- Jumper Settings 74
- Pins 1-2 BMC Enable 74
- Pins 2-3 Normal (Default) 74
- 5-10 Onboard Indicators 76
- 5-11 SATA Ports 77
- 5-12 Installing Software 78
- SuperDoctor III 79
- LTUM ATTERY 81
- ATTERY OLER 81
- Chapter 6 82
- Advanced Chassis Setup 82
- Hard Drives (24)Control Panel 83
- I/O Ports (see Figure 5-2) 83
- Release Tab 84
- Remove this screw 84
- (if necessary) 84
- 6-4 System Cooling 85
- Air Shrouds 86
- Accessing the Drive Bays 88
- 6-5 Power Supply 91
- Chapter 7 94
- 7-2 Main Setup 95
- XBoot Feature 97
- • Type of CPU 98
- • CPU Signature 98
- • Microcode Patch 98
- • CPU Stepping 98
- • Maximum / Minimum CPU Speed 98
- XChipset Confi guration 103
- XNorth Bridge 103
- XQPI Confi guration 104
- XDIMM Information 105
- XSouth Bridge Confi guration 106
- XSATA Confi guration 107
- XPCIe/PCI/PnP Confi guration 108
- XSuper IO Confi guration 110
- XSerial Port 1 Confi guration 110
- XSerial Port 2 Confi guration 110
- XConsole Redirection Settings 111
- XACPI Settings 114
- XME Subsystem 116
- XNIC Confi guration 116
- 7-4 Event Logs 118
- 7-5 IPMI 120
- BMC Network Confi guration 121
- 7-6 Boot 122
- 7-7 Security 123
- 7-8 Save & Exit 124
- Appendix A 126
- BIOS Error Beep Codes 126
- Appendix B 128
- System Specifi cations 128
- Regulatory Compliance 130
Relacionado con productos y manuales para Barebones Servidor Supermicro SuperStorage Server 2027R-E1R24L
Barebones Servidor Supermicro 5018D-MF Manual de usuario
(120 paginas)
(120 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.077 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales