Supermicro SYS-7046GT-TRF Manual de usuario Pagina 105
- Pagina / 120
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 7: BIOS
7-23
Clear BMC System Event Log
Clear BMC System Log
Select OK and press the <Enter> key to clear the BMC system log. Select Cancel
to keep the BMC System log. The options are OK and Cancel.
Caution: Any cleared information is unrecoverable. Make absolutely sure
that you no longer need any data stored in the log before clearing the
BMC Event Log.
XSet LAN Confi guration
Set this feature to confi gure the IPMI LAN adapter with a network address as shown
in the following graphics.
Channel Number
Enter the channel number for the SET LAN Confi g command.
Channel Number Status
This feature returns the channel status for the Channel Number selected above:
"Channel Number is OK" or "Wrong Channel Number".
XIP Address Confi guration
Parameter Selector
This item displays the parameter of your IP Address confi guration.
IP Address Source
Select the source of this machine's IP address. If Static is selected, you will need
to know and enter manually the IP address of this machine below. If DHCP is
selected, the BIOS will search for a DHCP (Dynamic Host Confi guration Protocol)
server in the network it is attached to, and request the next available IP address.
The options are DHCP and Static.
IP Address
This item displays the IP address for the IPMI connection detected.
XSubnet Mask Confi guration
Subnet masks tell the network which subnet this machine belongs to. The value
of each three-digit number separated by dots should not exceed 255.
Parameter Selector
Use this feature to select the parameter of your Subnet Masks confi guration.
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 3 System Interface 7
- Chapter 4 System Safety 7
- Chapter 1 9
- Introduction 9
- 1-2 Serverboard Features 10
- 1-3 Server Chassis Features 11
- Hard Drive/Drive Bays 12
- Front Control Panel 12
- Cooling System 12
- Backplane 12
- Chapter 1: Introduction 13
- System Block Diagram 13
- 1-5 Contacting Supermicro 14
- Chapter 2 15
- System Setup 15
- 2-3 Setting Up the System 16
- Choosing a Setup Location 17
- Warnings and Precautions! 18
- Rack Mounting Considerations 19
- Installing the Chassis Cover 25
- Chapter 3 27
- System Interface 27
- 3-2 Control Panel Buttons 28
- 3-3 Control Panel LEDs 28
- 3-4 Drive Carrier LEDs 30
- Chapter 4 31
- System Safety 31
- 4-3 ESD Precautions 33
- LITHIUM BATTERY 34
- BATTERY HOLDER 34
- Chapter 5 35
- Advanced Serverboard Setup 35
- 5-2 Serverboard Installation 36
- 5-3 Connecting Cables 37
- 2 1 38
- 20 19 38
- Back Panel Connectors 39
- Socket Clip Load Plate 40
- Plastic Cap 40
- 5-6 Installing Memory 43
- Memory Support 44
- 5-6 Adding PCI Add-On Cards 46
- 5-7 Serverboard Details 50
- 5-8 Connector Defi nitions 52
- Fan Header 55
- Pin Defi nitions 55
- Chassis Intrusion 55
- 5-9 Jumper Settings 60
- LAN1/2 Enable/Disable 61
- Jumper Settings 61
- USB Wake-Up 62
- 5-10 Onboard Indicators 63
- 5-11 SATA Ports 64
- 5-12 Installing Software 65
- Supero Doctor III 66
- Chapter 6 69
- Advanced Chassis Setup 69
- 6-1 Static-Sensitive Devices 70
- 6-2 Control Panel 70
- 6-3 System Cooling 71
- 6-4 Power Supply 73
- Power Supply Connections 74
- Tower or Rack Confi guration 75
- Rotating the Storage Module 76
- Removing a Drive Carrier 78
- Adding Peripheral Drives 80
- Chapter 7 83
- 7-2 Main Setup 84
- XBoot Features 86
- Processor and Clock Options 87
- XAdvanced Chipset Control 90
- XQPI and IMC Confi guration 90
- Route Port 80h Cycles to 93
- IDE/SATA/Floppy Confi guration 94
- XPCI/PnP Confi guration 97
- XRemote Access Confi guration 98
- Hardware Health Confi guration 99
- XACPI Confi guration 102
- XIPMI Confi guration 104
- View BMC System Event Log 104
- Set LAN Confi guration 105
- IP Address Confi guration 105
- Subnet Mask Confi guration 105
- Gateway Address Confi guration 106
- MAC Address Confi guration 106
- 7-4 Security Settings 107
- 7-5 Boot Confi guration 109
- 7-6 Exit Options 110
- Chapter 7: BIOS 111
- Load Fail-Safe Defaults 111
- Appendix A 113
- BIOS Error Beep Codes 113
- Appendix B 115
- Installing Windows 115
- Appendix C 117
- System Specifi cations 117
- Regulatory Compliance 119
Relacionado con productos y manuales para Barebones Servidor Supermicro SYS-7046GT-TRF
Barebones Servidor Supermicro 5013S-8 Manual de usuario
(110 paginas)
(110 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.062 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales