Supermicro SYS-7046GT-TRF Manual de usuario Pagina 15
- Pagina / 120
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 2: Server Installation
2-1
Chapter 2
System Setup
2-1 Overview
This chapter provides a quick setup checklist to get your SuperServer 7046GT-
TRF/7046GT-TRF-TC4 up and running. Following the steps in the order given
should enable you to have the system operational within a minimal amount of time.
If your system is not already fully integrated with a motherboard, processor, system
memory etc., please turn to the chapter or section noted in each step for details on
installing specifi c components.
2-2 Unpacking the System
You should inspect the box the SuperServer 7046GT-TRF/7046GT-TRF-TC4 was
shipped in and note if it was damaged in any way. If the server itself shows damage,
you should fi le a damage claim with the carrier who delivered it.
Decide on a suitable location for setting up and operating the SuperServer 7046GT-
TRF/7046GT-TRF-TC4. It should be situated in a clean, dust-free area that is well
ventilated. Avoid areas where heat, electrical noise and electromagnetic fi elds are
generated. You will also need it placed near a grounded power outlet.
!
!
Warnings and Precautions!
Review the electrical and general safety precautions in Chapter 4.•
Use a regulating uninterruptible power supply (UPS) to protect the server from •
power surges, voltage spikes and to keep your system operating in case of a
power failure.
Allow the power supply units and Serial ATA drives to cool before touching
•
them.
To maintain proper cooling, always keep all chassis panels closed when not
•
being serviced.
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 3 System Interface 7
- Chapter 4 System Safety 7
- Chapter 1 9
- Introduction 9
- 1-2 Serverboard Features 10
- 1-3 Server Chassis Features 11
- Hard Drive/Drive Bays 12
- Front Control Panel 12
- Cooling System 12
- Backplane 12
- Chapter 1: Introduction 13
- System Block Diagram 13
- 1-5 Contacting Supermicro 14
- Chapter 2 15
- System Setup 15
- 2-3 Setting Up the System 16
- Choosing a Setup Location 17
- Warnings and Precautions! 18
- Rack Mounting Considerations 19
- Installing the Chassis Cover 25
- Chapter 3 27
- System Interface 27
- 3-2 Control Panel Buttons 28
- 3-3 Control Panel LEDs 28
- 3-4 Drive Carrier LEDs 30
- Chapter 4 31
- System Safety 31
- 4-3 ESD Precautions 33
- LITHIUM BATTERY 34
- BATTERY HOLDER 34
- Chapter 5 35
- Advanced Serverboard Setup 35
- 5-2 Serverboard Installation 36
- 5-3 Connecting Cables 37
- 2 1 38
- 20 19 38
- Back Panel Connectors 39
- Socket Clip Load Plate 40
- Plastic Cap 40
- 5-6 Installing Memory 43
- Memory Support 44
- 5-6 Adding PCI Add-On Cards 46
- 5-7 Serverboard Details 50
- 5-8 Connector Defi nitions 52
- Fan Header 55
- Pin Defi nitions 55
- Chassis Intrusion 55
- 5-9 Jumper Settings 60
- LAN1/2 Enable/Disable 61
- Jumper Settings 61
- USB Wake-Up 62
- 5-10 Onboard Indicators 63
- 5-11 SATA Ports 64
- 5-12 Installing Software 65
- Supero Doctor III 66
- Chapter 6 69
- Advanced Chassis Setup 69
- 6-1 Static-Sensitive Devices 70
- 6-2 Control Panel 70
- 6-3 System Cooling 71
- 6-4 Power Supply 73
- Power Supply Connections 74
- Tower or Rack Confi guration 75
- Rotating the Storage Module 76
- Removing a Drive Carrier 78
- Adding Peripheral Drives 80
- Chapter 7 83
- 7-2 Main Setup 84
- XBoot Features 86
- Processor and Clock Options 87
- XAdvanced Chipset Control 90
- XQPI and IMC Confi guration 90
- Route Port 80h Cycles to 93
- IDE/SATA/Floppy Confi guration 94
- XPCI/PnP Confi guration 97
- XRemote Access Confi guration 98
- Hardware Health Confi guration 99
- XACPI Confi guration 102
- XIPMI Confi guration 104
- View BMC System Event Log 104
- Set LAN Confi guration 105
- IP Address Confi guration 105
- Subnet Mask Confi guration 105
- Gateway Address Confi guration 106
- MAC Address Confi guration 106
- 7-4 Security Settings 107
- 7-5 Boot Confi guration 109
- 7-6 Exit Options 110
- Chapter 7: BIOS 111
- Load Fail-Safe Defaults 111
- Appendix A 113
- BIOS Error Beep Codes 113
- Appendix B 115
- Installing Windows 115
- Appendix C 117
- System Specifi cations 117
- Regulatory Compliance 119
Relacionado con productos y manuales para Barebones Servidor Supermicro SYS-7046GT-TRF
Barebones Servidor Supermicro 5013S-8 Manual de usuario
(110 paginas)
(110 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.061 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales