Supermicro CSE-825TQ-600LPB Manual de usuario descargar pdf (Pagina 29)

5-7

Chapter 5: Chassis Setup and Maintenance

5-6 Slim DVD-ROM Installation or Replacement

Installing or Replacing a Slim DVD-ROM Drive

1. Power down the system and if necessary, remove the server from the rack.

2. Remove the chassis cover.

3. Unplug the drives power and data cables from the motherboard and/or back-

plane.

4. If you are adding a new DVD-ROM drive: Remove the mini-bezel (grate)

from the drive bay The bezel can be removed by pulling out the hard drive

beneath the DVD-ROM drive bay, then pulling the mini-bezel forward.

If you are replacing a drive: Locate the locking tab at the rear (left hand

side when viewed from the front) of the DVD-ROM drive. Push the tab toward

the drive and push the drive unit out the front of the chassis.

5. Insert the new drive unit in the slot until the tab locks in place.

6. Reconnect the data and power cables.

7. Replace the chassis cover (replace the server in the rack, if necessary) and

power up the system.

Figure 5-8: Slim DVD-ROM Location

DVD-ROM

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 69 70

Sin comentarios

Supermicro CSE-825TQ-600LPB Manual de usuario Pagina 29