Supermicro SuperServer 1027R-WC1R Manual de usuario Pagina 62

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 120
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 61
5-14
SUPERSERVER 1027R-WC1R/1027R-WC1RT User's Manual
Reset Button
The Reset Button connection is
located on pins 3 and 4 of JF1 and
attaches to the reset switch on the
computer chassis. See the table on
the right for pin de nitions.
Power Button
The Power On connection is on pins
1 and 2 of JF1. These should be
connected to the chassis power but-
ton. See the table on the right for pin
de nitions.
5-8 Connector De nitions
ATX Power 24-pin Connector
Pin De nitions
Pin# De nition Pin # De nition
13 +3.3V 1 +3.3V
14 -12V 2 +3.3V
15 COM 3 COM
16 PS_ON 4 +5V
17 COM 5 COM
18 COM 6 +5V
19 COM 7 COM
20 Res (NC) 8 PWR_OK
21 +5V 9 5VSB
22 +5V 10 +12V
23 +5V 11 +12V
24 COM 12 +3.3V
Reset Button
Pin De nitions (JF1)
Pin# De nition
3 Reset
4 Ground
Power Button
Pin De nitions (JF1)
Pin# De nition
1 Power Signal
2 Ground
Secondary Power Connector
JPW2 and JPW3 must also be con-
nected to the power supply. See the
table on the right for pin de nitions.
+12V 8-pin Power Connector
Pin De nitions
Pins De nition
1 - 4 Ground
5 - 8 +12V
Warning: To provide adequate power
supply to the serverboard, be sure to
connect all three power connectors
to the power supply. Failure to do so
will void the manufacturer warranty on
your power supply and serverboard.
Power Connectors
A 24-pin main power supply connector
(JPW1), two 8-pin CPU power con-
nectors (JPW2/3) must be connected
to the power supply. These power
connectors meet the SSI EPS 12V
speci cation. See the table on the
right for pin de nitions.
NC = No Connection
Vista de pagina 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 119 120

Comentarios a estos manuales

Sin comentarios