Supermicro SuperServer 1027R-WC1R Manual de usuario Pagina 63
- Pagina / 120
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 5: Advanced Serverboard Setup
5-15
Overheat (OH)/Fan Fail/PWR Fail/
UID LED
Connect an LED cable to pins 7 and
8 of Front Control Panel to use the
Overheat/Fan Fail/Power Fail and
UID LED connections. The Red LED
on pin 7 provides warnings of over-
heat, fan failure or power failure. The
Blue LED on pin 8 works as the front
panel UID LED indicator. The Red
LED takes precedence over the Blue
LED by default. Refer to the table on
the right for pin defi nitions.
HDD LED
The HDD LED connection is located
on pins 13 and 14 of JF1. This LED
is used to display all hard drive activ-
ity. See the table on the right for pin
defi nitions.
NIC2 LED
Pin Defi nitions (JF1)
Pin# Defi nition
9 Vcc
10 Ground
HDD LED
Pin Defi nitions (JF1)
Pin# Defi nition
13 Vcc
14 HD Active
NIC2 LED
The LED connections for LAN2 are
on pins 9 and 10 of JF1. Attach an
LED cable to display network activ-
ity. See the table on the right for pin
defi nitions.
NIC1 LED
Pin Defi nitions (JF1)
Pin# Defi nition
11 Vcc
12 Ground
NIC1 LED
The LED connections for LAN1 are
on pins 11 and 12 of JF1. Attach an
LED cable to display network activ-
ity. See the table on the right for pin
defi nitions.
OH/Fan Fail Indicator
Status
State Defi nition
Off Normal
On Overheat
Flashing Fan Fail
Power Fail LED
The Power Fail LED connection is lo-
cated on pins 5 and 6 of JF1. See the
table on the right for pin defi nitions.
PWR Fail LED
Pin Defi nitions (JF1)
Pin# Defi nition
5 3.3V
6 Signal
OH/Fan Fail/ PWR Fail/Blue_UID
LED Pin Defi nitions (JF1)
Pin# Defi nition
7 Red_LED-Cathode/OH/Fan Fail/
Power Fail5.5V.SB
8 Blue_UID LED
- SUPER 1
- Manual Revision 1.0 2
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 1 9
- Introduction 9
- 1-2 Serverboard Features 10
- 1-3 Server Chassis Features 11
- System Block Diagram 12
- 1-4 Contacting Supermicro 13
- Chapter 2 15
- Server Installation 15
- 2-4 Warnings and Precautions 16
- Rack Mounting Considerations 17
- Inner Rails 18
- Inner Rail 18
- Extensions 18
- Inner Rail Extension 19
- Outer Rails 20
- Chapter 3 25
- System Interface 25
- 3-3 Control Panel LEDs 26
- 3-4 Hard Drive Carrier LEDs 28
- Chapter 4 29
- ﺔﻴﺋﺎﺑﺮﻬﻜﻟﺍ 31
- Installation Instructions 32
- Circuit Breaker 33
- Power Disconnection Warning 34
- ילמשח קותינ ינפמ הרהזא 35
- Equipment Installation 36
- Restricted Area 37
- Battery Handling 38
- Redundant Power Supplies 40
- Backplane Voltage 41
- Product Disposal 43
- רצומה קוליס 44
- Power Cable and AC Adapter 46
- (UL/CSA ﻞﻤﺤﺗ ﻲﺘﻟﺍﺔﻣﻼﻋ ) 47
- Chapter 5 49
- Advanced Serverboard Setup 49
- • Control Panel cable (JF1) 50
- 5-3 Rear I/O Ports 51
- OPEN 1st 52
- WARNING! 53
- 5-5 Installing Memory 56
- DIMM Module Population Table 57
- 5-6 Adding PCI Add-On Cards 59
- 5-7 Serverboard Details 60
- 5-8 Connector Defi nitions 62
- USB 4, 8, 6 65
- Pin # Defi nition 65
- USB 5, 9 65
- Pin # Defi nition 65
- 5-9 Jumper Settings 68
- 5-10 Onboard Indicators 71
- 5-11 SATA and SAS Ports 72
- 5-12 Installing Software 73
- SuperDoctor® 5 74
- 5-13 Onboard Battery 75
- Chapter 6 77
- Advanced Chassis Setup 77
- 6-2 Control Panel 78
- 6-3 System Fans 79
- Checking the Airfl ow 81
- Accessing the Drive Bays 81
- Hard Drive Installation 81
- 6-5 Power Supply 84
- Chapter 7 85
- 7-2 Main Setup 86
- Boot Features 87
- Power Confi guration 88
- CPU Confi guration 88
- Chipset Confi guration 93
- North Bridge 93
- Integrated IO Confi guration 93
- QPI Confi guration 94
- DIMM Confi guration 95
- DIMM Information 95
- South Bridge Confi guration 97
- SATA Confi guration 98
- PCIe/PCI/PnP Confi guration 99
- Super IO Confi guration 100
- COM Confi guration 101
- • COM 1 and SOL 102
- ACPI Setting 105
- TPM Enable Status 106
- • ME BIOS Interface Version 107
- • ME Version 107
- 7-5 IPMI 109
- BMC Network Confi guration 110
- 7-6 Boot 111
- • 1st Device 112
- • 1st Boot Device 112
- 7-8 Save & Exit 113
- • LAN Device 114
- • UEFI: Built-in EFI Shell 114
- Appendix A 115
- BIOS Error Beep Codes 115
- Appendix B 117
- System Specifi cations 117
Relacionado con productos y manuales para Barebones Servidor Supermicro SuperServer 1027R-WC1R
Barebones Servidor Supermicro 188411 Manual de usuario
(122 paginas)
(122 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.038 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales