Supermicro SuperServer 6028R-WTRT Manual de usuario descargar pdf (Pagina 119)

A-1

Appendix A: BIOS POST Error Codes

Appendix A

BIOS Error Beep Codes

During the POST (Power-On Self-Test) routines, which are performed at each

system boot, errors may occur.

Non-fatal errors are those which, in most cases, allow the system to continue to

boot. The error messages normally appear on the screen.

Fatal errors will not allow the system to continue with bootup procedure. If a

fatal error occurs, you should consult with your system manufacturer for possible

repairs.

These fatal errors are usually communicated through a series of audible beeps.

The numbers on the fatal error list correspond to the number of beeps for the

corresponding error.

Beep Code Error Message Description

1 beep Refresh Circuits have been reset (Ready to power up)

5 short beeps and 1

long beep

Memory error No memory detected in the system

5 beeps No Con-In or No

Con-Out devices

Con-In: USB or PS/2 keyboard, PCI or Serial Console

Redirection, IPMI KVM or SOL

Con-Out: Video Controller, PCI or Serial Console Redirection,

IPMI SOL

1 beep per device Refresh 1 beep for each USB device

IPMI Error Codes

1 continuous beep System overheat System overheat

1 2 ... 114 115 116 117 118 119 120 121 122 123 124

Sin comentarios

Supermicro SuperServer 6028R-WTRT Manual de usuario Pagina 119