Supermicro SuperServer 6028R-WTRT Manual de usuario descargar pdf (Pagina 20)

2-4

SUPERSERVER 6027R-73DARF User's Manual

2-4 Installing the System into a Rack

This section provides information on installing the SC815 chassis into a rack unit

with the quick-release rails provided. There are a variety of rack units on the market,

which may mean the assembly procedure will differ slightly. You should also refer to

the installation instructions that came with the rack unit you are using.

Note: This rail will ﬁ t a rack between 26" and 33.5" deep.

Warning: Do not pick up the server with the front handles. They are

designed to pull the system from a rack only.

Stability Hazard: The rack stabilizing mechanism must be in place, or the

rack must be bolted to the ﬂ oor before you slide the unit out for servicing. Failure

to stabilize the rack can cause the rack to tip over.

Warning: Slide rail mounted equipment is not to be used as a shelf or a

work space.

Separating the Sections of the Rack Rails

The chassis package includes two rail assemblies in the rack mounting kit. Each

assembly consists of two sections: an inner ﬁ xed chassis rail that secures directly to

the server chassis and an outer ﬁ xed rack rail that secures directly to the rack itself.

Installing the Inner Rail Extension

The SC825 chassis includes a set of inner rails in two sections: inner rails and

inner rail extensions. Inner rail extensions are attached to the inner rails to mount

the chassis in the rack.

Installing the Inner Rails

1. Place the inner rail extensions on the side of the chassis aligning the hooks

of the chassis with the rail extension holes. Make sure the extension faces

"outward" just like the pre-attached inner rail.

2. Slide the extension toward the front of the chassis.

3. Secure the chassis with 2 screws as illustrated. Repeat steps for the other

inner rail extension.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 123 124

Sin comentarios

Supermicro SuperServer 6028R-WTRT Manual de usuario Pagina 20