Supermicro SuperServer 7036A-T Manual de usuario descargar pdf (Pagina 30)

5-2

SUPERWORKSTATION 7036A-T User's Manual

Unpacking

The serverboard is shipped in antistatic packaging to avoid electrical static dis-

charge. When unpacking the board, make sure the person handling it is static

protected.

5-2 Serverboard Installation

This section explains the ﬁ rst step of physically mounting the X8DAL-i into the

SC733TQ-665B chassis. Following the steps in the order given will eliminate

the most common problems encountered in such an installation. To remove the

serverboard, follow the procedure in reverse order.

nstalling to the Chassis

Access the inside of the system by removing the screws from the back lip of 1.

the top cover of the chassis, then pull the cover off.

The X8DAL-i requires a chassis big enough to support a 12" x 10" 2.

serverboard, such as Supermicro's SC733TQ-665.

Make sure that the I/O ports on the serverboard align properly with their 3.

respective holes in the I/O shield at the back of the chassis.

Carefully mount the serverboard to the serverboard tray by aligning the board 4.

holes with the raised metal standoffs that are visible in the chassis.

Insert screws into all the mounting holes on your serverboard that line up 5.

with the standoffs and tighten until snug (if you screw them in too tight, you

might strip the threads). Metal screws provide an electrical contact to the

serverboard ground to provide a continuous ground for the system.

Finish by replacing the top cover of the chassis.6.

Warning: To avoid damaging the serverboard and its components, do not apply

any force greater than 8 lbs. per square inch when installing a screw into a mount-

ing hole.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 95 96

Sin comentarios

Supermicro SuperServer 7036A-T Manual de usuario Pagina 30