Supermicro SuperServer 7036A-T Manual de usuario Pagina 60
- Pagina / 96
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
6-6
SUPERWORKSTATION 7036A-T Manual
Important! Use extreme caution when working around the SATA back-
plane. Do not touch the backplane with any metal objects and make sure
no ribbon cables touch the backplane or obstruct the airfl ow holes in the
SATA backplane. Regardless of how many SATA hard drives are installed,
all four SATA drive carriers must remain in the drive bays to promote
proper airfl ow.
!
6-4 Drive Bay Installation
A bezel covers the front of the chassis but does not need to be removed to access
the drives. If you wish to remove the bezel piece, push on the three tabs on the
inside left side lip of the front chassis cover. Then slightly swing out the same (left)
side of the cover - about ½ inch only. Remove by pushing on the open side of the
cover to remove it from the chassis (do not try to swing or pull it straight out after
opening the left side.
Serial ATA Drives
The hot-swappable SATA drives are mounted in drive carriers to simplify their instal-
lation and removal from the chassis. These carriers also work to promote proper
airfl ow for the system. For this reason, even carriers without SATA drives must
remain in the workstation.
After unlocking the Serial ATA (SATA) drive bay door, swing it open to access the
SATA drive. The drive IDs are preconfi gured as 0 through 3 in order from bottom
to top. These SATA drives are hot-pluggable, meaning they can be removed and
installed without powering down the system.
Removing SATA drives
To remove a carrier, fi rst open the front bezel then push the release button 1.
located beside the drive LEDs.
Swing the colored handle fully out and use it to pull the unit straight out (see 2.
Figure 6-4). Note: Your operating system must have RAID support to enable
the hot-plug capability of the SATA drives.
Mounting a SATA drive in a drive carrier
Insert the drive into the carrier with the printed circuit board side facing down 1.
so that the mounting holes align with those in the carrier.
Secure the drive to the carrier with four screws.2.
- SUPER 1
- Manual Revision 1.0b 2
- Release Date: March 14, 2011 2
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 7 BIOS 9
- Appendix B Installing Windows 9
- Chapter 1 11
- Introduction 11
- 1-2 Serverboard Features 12
- 1-3 Chassis Features 13
- System Block Diagram 14
- 1-4 Contacting Supermicro 15
- Chapter 2 17
- System Setup 17
- 2-3 Setting Up the System 18
- Chapter 2: System Setup 19
- Chapter 3 21
- System Interface 21
- 3-3 Control Panel LEDs 22
- 3-4 SATA Drive Carrier LEDs 23
- Chapter 4 25
- System Safety 25
- 4-3 ESD Precautions 27
- LITHIUM BATTERY 28
- BATTERY HOLDER 28
- Chapter 5 29
- Advanced Serverboard Setup 29
- 5-2 Serverboard Installation 30
- 5-3 Connecting Cables 31
- 5-4 I/O Ports 32
- Socket Clip Load Plate 33
- Plastic Cap 33
- CPU Socket 34
- Load Plate 34
- Installing a CPU Heatsink 35
- 5-6 Installing Memory 36
- Populating DIMMs 37
- 5-8 Serverboard Details 39
- X8DAL-i Quick Reference 40
- 5-9 Connector Defi nitions 41
- 5-10 Jumper Settings 47
- 5-11 Onboard Indicators 49
- 5-12 SATA Ports 50
- 5-13 Installing Software 51
- Supero Doctor III 52
- Chapter 6 55
- Advanced Chassis Setup 55
- 6-2 Front Control Panel 56
- 6-3 System Fans 58
- Installing a new fan 59
- 6-4 Drive Bay Installation 60
- 6-5 Power Supply 63
- Chapter 7 65
- 7-2 Main Setup 66
- XBoot Features 67
- XPower Confi guration 68
- Processor and Clock Options 69
- XAdvanced Chipset Control 71
- XCPU Bridge Confi guration 71
- XNorth Bridge Confi guration 72
- XSouth Bridge Confi guration 73
- IDE/SATA Confi guration 74
- XPCI/PnP Confi guration 77
- XRemote Access Confi guration 79
- Hardware Health Monitor 80
- XACPI Confi guration 82
- XEvent Log Confi guration 83
- 7-4 Security Settings 84
- 7-5 Boot Confi guration 85
- XCD/DVD Drives 86
- XUSB Drives 86
- XNetwork Drives 86
- 7-6 Exit Options 87
- Appendix A 89
- BIOS Error Beep Codes 89
- Appendix B 91
- Installing Windows 91
- Appendix C 93
- System Specifi cations 93
Relacionado con productos y manuales para Barebones Servidor Supermicro SuperServer 7036A-T
(108 paginas)
(42 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.053 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales