Supermicro SuperStorage Server 6027R-E1R12T Manual de usuario Pagina 118
- Pagina / 128
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
7-28
SuperStorageSystem 6027R-E1R12T User's Manual
Log EFI Status Codes
Select Enabled to log EFI (Extensible Firmware Interface) Status Codes, Error
Codes or Progress Codes. The options are disabled an Enabled.
Note: After making changes on a setting, be sure to reboot the system for
the changes to take effect.
X
BMC Network Confi guration
LAN Channel 1: This feature allows the user to confi gure the settings for LAN
Channel 1.
Update IPMI LAN Confi guration
This feature allows the BIOS to implement any IP/MAC address changes at the next
system boot. If the option is set to Yes, any changes made to the settings below will
take effect when the system is rebooted. The options are No and Yes.
Confi guration Address Source
This feature allows the user to select the source of the IP address for this com-
puter. If Static is selected, you will need to know the IP address of this computer
and enter it to the system manually in the fi eld. If DHCP is selected, the BIOS will
search for a DHCP (Dynamic Host Confi guration Protocol) server in the network
that it is attached to and request the next available IP address for this computer.
The options are DHCP and Static.
Station IP Address
This item displays the Station IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This item displays the sub-network that this computer belongs to. The value of each
three-digit number separated by dots should not exceed 255.
Station MAC Address
This item displays the Station Mac address for this computer. Mac addresses are
6 two-digit hexadecimal numbers.
Gateway IP Address
This item displays the Gateway IP address for this computer. This should be in
decimal and in dotted quad form (i.e., 192.168.10.253).
- SUPER 1
- Manual Revision 1.0 2
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 3 System Interface 7
- Chapter 7 BIOS 8
- Chapter 1 11
- Introduction 11
- 1-2 Serverboard Features 12
- 1-3 Server Chassis Features 13
- LANE1/2/3/4 14
- 1-4 Contacting Supermicro 15
- Chapter 2 17
- Server Installation 17
- 2-4 Warnings and Precautions 18
- Rack Mounting Considerations 19
- Locking Tabs 20
- The Inner Rail Extension 21
- Outer Rack Rails 22
- Chapter 3 25
- System Interface 25
- 3-3 Control Panel LEDs 26
- 3-2 Control Panel Buttons 26
- 3-4 Drive Carrier LEDs 28
- Chapter 4 29
- ﺔﻴﺋﺎﺑﺮﻬﻜﻟﺍ 31
- Installation Instructions 32
- 250 V, 20 A 33
- Power Disconnection Warning 34
- ילמשח קותינ ינפמ הרהזא 35
- Equipment Installation 36
- Restricted Area 37
- Battery Handling 38
- Redundant Power Supplies 40
- Backplane Voltage 41
- Product Disposal 43
- רצומה קוליס 44
- Power Cable and AC Adapter 46
- (UL/CSA ﻞﻤﺤﺗ ﻲﺘﻟﺍﺔﻣﻼﻋ ) 47
- Chapter 5 49
- Advanced Serverboard Setup 49
- • Control Panel cable (JF1) 50
- 2 1 51
- 20 19 51
- Press down on 52
- 'Close 1st' 52
- Pull lever away 52
- WARNING! 53
- OPEN 1st 54
- Removing the Heatsink 55
- Installing a CPU Heatsink 55
- 5-5 Installing Memory 56
- 1 CPU, 2 DIMMs 57
- 1 CPU, 4 DIMMs 57
- 1 CPU, 5~8 DIMMs 57
- 2 CPUs, 4 DIMMs 58
- 2 CPUs, 6 DIMMs 58
- 2 CPUs, 8 DIMMs 58
- 5-6 Adding PCI Add-On Cards 61
- 5-7 Serverboard Details 62
- X9DRH-7TF Quick Reference 63
- 5-8 Connector Defi nitions 65
- USB 4, 6 70
- Pin # Defi nition 70
- Pin # Defi nition 70
- JLAN1/2 Enable/Disable 71
- Jumper Settings 71
- Pins 1-2 Enabled (default) 71
- Pins 2-3 Disabled 71
- 5-10 Onboard Indicators 73
- 5-11 SAS and SATA Ports 74
- 5-12 Installing Software 75
- SuperDoctor III 76
- 5-13 Onboard Battery 78
- Chapter 6 79
- Advanced Chassis Setup 79
- Control Panel SATA Drives (8) 80
- Optional Drive Bays (2) 80
- I/O Ports 80
- 6-4 System Fans 81
- Replacing System Fans 82
- 6-5 Air Shroud 83
- Accessing the Drive Bays 84
- SATA Drive Installation 84
- Hard Drive Backplane 86
- 6-7 Power Supply 87
- Release Tab 88
- Power Distributor 89
- Chapter 7 91
- 7-2 Main Setup 92
- Boot Feature 94
- • Type of CPU 95
- • CPU Signature 95
- • Microcode Patch 95
- Socket 1 CPU Information 96
- Chipset Confi guration 100
- North Bridge 100
- QPI Confi guration 101
- DIMM Confi guration 102
- South Bridge 104
- SATA Confi guration 105
- SCU Confi guration 106
- PCIe/PCI/PnP Confi guration 106
- XSuper IO Confi guration 108
- XSerial Port 1 Confi guration 108
- XSerial Port 2 Confi guration 108
- Console Redirection Settings 109
- ACPI Settings 112
- • ME BIOS Interface 114
- • ME Version 114
- 7-4 Event Logs 115
- 7-5 IPMI 117
- BMC Network Confi guration 118
- 7-6 Boot 119
- 7-7 Security 120
- 7-8 Save & Exit 121
- Appendix A 123
- BIOS Error Beep Codes 123
- Appendix B 125
- System Specifi cations 125
- Regulatory Compliance 127
Relacionado con productos y manuales para Barebones Servidor Supermicro SuperStorage Server 6027R-E1R12T
Barebones Servidor Supermicro 5018D-MF Manual de usuario
(120 paginas)
(120 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.060 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales