Supermicro SuperStorage Server 6027R-E1R12T Manual de usuario Pagina 80
- Pagina / 128
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
6-2
SUPERSTORAGESYSTEM 6027R-E1R12L User's Manual
Figure 6-1. Front and Rear Chassis Views
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the Control Panel PCB (printed circuit
board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess
cabling out of the airfl ow path. The LEDs inform you of system status.
See Chapter 3 for details on the LEDs and the control panel buttons. Details on
JF1 can be found in Chapter 5.
6-3 Accessing the Inside of the Chassis
Some maintenance will require accessing the inside of the server.
Removing the Chassis Cover (Figure 6-2)
1. Remove the two screws from the sides of the chassis cover.
2. Press both release tabs at the same time to unlock the cover.
3. Slide the cover toward the rear of the chassis.
4. Lift the cover off the chassis.
Control Panel SATA Drives (8)
Power Supplies 7 Low-profi le PCI Slots
Optional Drive Bays (2)
I/O Ports
- SUPER 1
- Manual Revision 1.0 2
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 3 System Interface 7
- Chapter 7 BIOS 8
- Chapter 1 11
- Introduction 11
- 1-2 Serverboard Features 12
- 1-3 Server Chassis Features 13
- LANE1/2/3/4 14
- 1-4 Contacting Supermicro 15
- Chapter 2 17
- Server Installation 17
- 2-4 Warnings and Precautions 18
- Rack Mounting Considerations 19
- Locking Tabs 20
- The Inner Rail Extension 21
- Outer Rack Rails 22
- Chapter 3 25
- System Interface 25
- 3-3 Control Panel LEDs 26
- 3-2 Control Panel Buttons 26
- 3-4 Drive Carrier LEDs 28
- Chapter 4 29
- ﺔﻴﺋﺎﺑﺮﻬﻜﻟﺍ 31
- Installation Instructions 32
- 250 V, 20 A 33
- Power Disconnection Warning 34
- ילמשח קותינ ינפמ הרהזא 35
- Equipment Installation 36
- Restricted Area 37
- Battery Handling 38
- Redundant Power Supplies 40
- Backplane Voltage 41
- Product Disposal 43
- רצומה קוליס 44
- Power Cable and AC Adapter 46
- (UL/CSA ﻞﻤﺤﺗ ﻲﺘﻟﺍﺔﻣﻼﻋ ) 47
- Chapter 5 49
- Advanced Serverboard Setup 49
- • Control Panel cable (JF1) 50
- 2 1 51
- 20 19 51
- Press down on 52
- 'Close 1st' 52
- Pull lever away 52
- WARNING! 53
- OPEN 1st 54
- Removing the Heatsink 55
- Installing a CPU Heatsink 55
- 5-5 Installing Memory 56
- 1 CPU, 2 DIMMs 57
- 1 CPU, 4 DIMMs 57
- 1 CPU, 5~8 DIMMs 57
- 2 CPUs, 4 DIMMs 58
- 2 CPUs, 6 DIMMs 58
- 2 CPUs, 8 DIMMs 58
- 5-6 Adding PCI Add-On Cards 61
- 5-7 Serverboard Details 62
- X9DRH-7TF Quick Reference 63
- 5-8 Connector Defi nitions 65
- USB 4, 6 70
- Pin # Defi nition 70
- Pin # Defi nition 70
- JLAN1/2 Enable/Disable 71
- Jumper Settings 71
- Pins 1-2 Enabled (default) 71
- Pins 2-3 Disabled 71
- 5-10 Onboard Indicators 73
- 5-11 SAS and SATA Ports 74
- 5-12 Installing Software 75
- SuperDoctor III 76
- 5-13 Onboard Battery 78
- Chapter 6 79
- Advanced Chassis Setup 79
- Control Panel SATA Drives (8) 80
- Optional Drive Bays (2) 80
- I/O Ports 80
- 6-4 System Fans 81
- Replacing System Fans 82
- 6-5 Air Shroud 83
- Accessing the Drive Bays 84
- SATA Drive Installation 84
- Hard Drive Backplane 86
- 6-7 Power Supply 87
- Release Tab 88
- Power Distributor 89
- Chapter 7 91
- 7-2 Main Setup 92
- Boot Feature 94
- • Type of CPU 95
- • CPU Signature 95
- • Microcode Patch 95
- Socket 1 CPU Information 96
- Chipset Confi guration 100
- North Bridge 100
- QPI Confi guration 101
- DIMM Confi guration 102
- South Bridge 104
- SATA Confi guration 105
- SCU Confi guration 106
- PCIe/PCI/PnP Confi guration 106
- XSuper IO Confi guration 108
- XSerial Port 1 Confi guration 108
- XSerial Port 2 Confi guration 108
- Console Redirection Settings 109
- ACPI Settings 112
- • ME BIOS Interface 114
- • ME Version 114
- 7-4 Event Logs 115
- 7-5 IPMI 117
- BMC Network Confi guration 118
- 7-6 Boot 119
- 7-7 Security 120
- 7-8 Save & Exit 121
- Appendix A 123
- BIOS Error Beep Codes 123
- Appendix B 125
- System Specifi cations 125
- Regulatory Compliance 127
Relacionado con productos y manuales para Barebones Servidor Supermicro SuperStorage Server 6027R-E1R12T
Barebones Servidor Supermicro 5018D-MF Manual de usuario
(120 paginas)
(120 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.145 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales