Supermicro SuperStorage Server 6027R-E1R12T Manual de usuario Pagina 65
- Pagina / 128
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 5: Advanced Serverboard Setup
5-17
Reset Button
The Reset Button connection is
located on pins 3 and 4 of JF1 and
attaches to the reset switch on the
computer chassis. See the table on
the right for pin defi nitions.
Power Button
The Power On connection is on pins
1 and 2 of JF1. These should be
connected to the chassis power but-
ton. See the table on the right for pin
defi nitions.
5-8 Connector Defi nitions
Required Connection
ATX Power 24-pin Connector
Pin Defi nitions
Pin# Defi nition Pin # Defi nition
13 +3.3V 1 +3.3V
14 -12V 2 +3.3V
15 COM 3 COM
16 PS_ON 4 +5V
17 COM 5 COM
18 COM 6 +5V
19 COM 7 COM
20 Res (NC) 8 PWR_OK
21 +5V 9 5VSB
22 +5V 10 +12V
23 +5V 11 +12V
24 COM 12 +3.3V
Reset Button
Pin Defi nitions (JF1)
Pin# Defi nition
3 Reset
4 Ground
Power Button
Pin Defi nitions (JF1)
Pin# Defi nition
1 Power Signal
2 Ground
Secondary Power Connector
JPWR1 and JPWR2 must also be
connected to the power supply. See
the table on the right for pin defi ni-
tions.
Power Connectors
A 24-pin main power supply
connector(J22) and two 8-pin power
connectors (JPWR1/JPWR2) are
provided on the serverboard. These
power connectors meet the SSI EPS
12V specifi cation. These power con-
nectors must be connected to your
power supply. See the table on the
right for pin defi nitions.
+12V 8-pin Power
Pin Defi nitions
Pins Defi nition
1 - 4 Ground
5 - 8 +12V
- SUPER 1
- Manual Revision 1.0 2
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 3 System Interface 7
- Chapter 7 BIOS 8
- Chapter 1 11
- Introduction 11
- 1-2 Serverboard Features 12
- 1-3 Server Chassis Features 13
- LANE1/2/3/4 14
- 1-4 Contacting Supermicro 15
- Chapter 2 17
- Server Installation 17
- 2-4 Warnings and Precautions 18
- Rack Mounting Considerations 19
- Locking Tabs 20
- The Inner Rail Extension 21
- Outer Rack Rails 22
- Chapter 3 25
- System Interface 25
- 3-3 Control Panel LEDs 26
- 3-2 Control Panel Buttons 26
- 3-4 Drive Carrier LEDs 28
- Chapter 4 29
- ﺔﻴﺋﺎﺑﺮﻬﻜﻟﺍ 31
- Installation Instructions 32
- 250 V, 20 A 33
- Power Disconnection Warning 34
- ילמשח קותינ ינפמ הרהזא 35
- Equipment Installation 36
- Restricted Area 37
- Battery Handling 38
- Redundant Power Supplies 40
- Backplane Voltage 41
- Product Disposal 43
- רצומה קוליס 44
- Power Cable and AC Adapter 46
- (UL/CSA ﻞﻤﺤﺗ ﻲﺘﻟﺍﺔﻣﻼﻋ ) 47
- Chapter 5 49
- Advanced Serverboard Setup 49
- • Control Panel cable (JF1) 50
- 2 1 51
- 20 19 51
- Press down on 52
- 'Close 1st' 52
- Pull lever away 52
- WARNING! 53
- OPEN 1st 54
- Removing the Heatsink 55
- Installing a CPU Heatsink 55
- 5-5 Installing Memory 56
- 1 CPU, 2 DIMMs 57
- 1 CPU, 4 DIMMs 57
- 1 CPU, 5~8 DIMMs 57
- 2 CPUs, 4 DIMMs 58
- 2 CPUs, 6 DIMMs 58
- 2 CPUs, 8 DIMMs 58
- 5-6 Adding PCI Add-On Cards 61
- 5-7 Serverboard Details 62
- X9DRH-7TF Quick Reference 63
- 5-8 Connector Defi nitions 65
- USB 4, 6 70
- Pin # Defi nition 70
- Pin # Defi nition 70
- JLAN1/2 Enable/Disable 71
- Jumper Settings 71
- Pins 1-2 Enabled (default) 71
- Pins 2-3 Disabled 71
- 5-10 Onboard Indicators 73
- 5-11 SAS and SATA Ports 74
- 5-12 Installing Software 75
- SuperDoctor III 76
- 5-13 Onboard Battery 78
- Chapter 6 79
- Advanced Chassis Setup 79
- Control Panel SATA Drives (8) 80
- Optional Drive Bays (2) 80
- I/O Ports 80
- 6-4 System Fans 81
- Replacing System Fans 82
- 6-5 Air Shroud 83
- Accessing the Drive Bays 84
- SATA Drive Installation 84
- Hard Drive Backplane 86
- 6-7 Power Supply 87
- Release Tab 88
- Power Distributor 89
- Chapter 7 91
- 7-2 Main Setup 92
- Boot Feature 94
- • Type of CPU 95
- • CPU Signature 95
- • Microcode Patch 95
- Socket 1 CPU Information 96
- Chipset Confi guration 100
- North Bridge 100
- QPI Confi guration 101
- DIMM Confi guration 102
- South Bridge 104
- SATA Confi guration 105
- SCU Confi guration 106
- PCIe/PCI/PnP Confi guration 106
- XSuper IO Confi guration 108
- XSerial Port 1 Confi guration 108
- XSerial Port 2 Confi guration 108
- Console Redirection Settings 109
- ACPI Settings 112
- • ME BIOS Interface 114
- • ME Version 114
- 7-4 Event Logs 115
- 7-5 IPMI 117
- BMC Network Confi guration 118
- 7-6 Boot 119
- 7-7 Security 120
- 7-8 Save & Exit 121
- Appendix A 123
- BIOS Error Beep Codes 123
- Appendix B 125
- System Specifi cations 125
- Regulatory Compliance 127
Relacionado con productos y manuales para Barebones Servidor Supermicro SuperStorage Server 6027R-E1R12T
Barebones Servidor Supermicro 5018D-MF Manual de usuario
(120 paginas)
(120 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.037 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales