Supermicro SYS-7046A-6 Manual de usuario Pagina 55

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 98
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 54
Chapter 5: Advanced Serverboard Setup
5-23
5-12 Floppy, SAS and SATA Ports
SATA Port
Pin De nitions
Pin # De nition
1 Ground
2 TXP
3 TXN
4 Ground
5 RXN
6 RXP
7 Ground
SATA Ports
Six Serial ATA (SATA) ports (I-SATA
0~5) are located on the serverboard to
provide serial link connections. Serial
Link connections provide faster data
transmission than those of the tradi-
tional Parallel ATA. These SATA ports
are supported by the Intel ICH10R
Chip (South Bridge). See the table on
the right for pin de nitions.
Floppy Connector
The oppy connector is located be-
tween the COM port and FireWire
headers on the motherboard. See the
table on the right for pin de nitions.
Note the following when connecting
the oppy cable:
The oppy disk drive cable has
seven twisted wires.
A red mark on a wire typically des-
ignates the location of pin 1.
A single oppy disk drive ribbon
cable has 34 wires and two con-
nectors to provide for two oppy
disk drives. The connector with
twisted wires always connects to
drive A, and the connector that
does not have twisted wires al-
ways connects to drive B.
Floppy Drive Connector
Pin De nitions
Pin# De nition Pin # De nition
1 Ground 2 FDHDIN
3 Ground 4 Reserved
5 Key 6 FDEDIN
7 Ground 8 Index
9 Ground 10 Motor Enable
11 Ground 12 Drive Select B
13 Ground 14 Drive Select B
15 Ground 16 Motor Enable
17 Ground 18 DIR
19 Ground 20 STEP
21 Ground 22 Write Data
23 Ground 24 Write Gate
25 Ground 26 Track 00
27 Ground 28 Write Protect
29 Ground 30 Read Data
31 Ground 32 Side 1 Select
33 Ground 34 Diskette
SAS Ports
An LSI 2008 SAS2 controller provides eight SAS ports on the X8DA6. To con gure
LSI SAS RAID settings, please refer to the LSI SAS RAID User Guide posted on
our Web site @http://www.supermicro.com/support/manuals/.
Vista de pagina 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 97 98

Comentarios a estos manuales

Sin comentarios