
G-3
Appendix G: SC836B Chassis Specications
Figure G-3. Securing the Backplane to the hard drive cage
Figure G-2. Removing the Dummy Drive from the Hard Drive Bay
Installing Hard Drives into the Rear Hard Drive Carrier
Installing the Rear Hard Drive Cage
1. Disconnect the power from the chassis by unplugging the power cord.
1
2
1
3
1
4
1
5
2. Remove the screws securing the dummy cover into the rear peripheral drive
bay. These screws are located on the underside of the chassis on the left-
hand side.
3. Pull the dummy drive out of the hard drive bay.
Comentarios a estos manuales