Supermicro SuperChassis 836BA-R1K28B Manual de usuario descargar pdf (Pagina 142)

SC836 Chassis Manual

G-6

Figure G-8. Removing the Dummy Drive from the Hard Drive Carrier

Installing Hard Drives in the Rear Hard Drive Carriers

The 2.5" hard drives to be installed in the rear of the SC836B are hot-swappable

and may be installed without powering down the server.

Note that only enterprise level hard drives are recommended for use in Supermicro

chassis.

Installing the Hard Drives in the Carrier

1. Remove the screws securing the dummy drive to the hard drive carrier and

remove the dummy drive from the carrier.

2. Insert a hard drive into the carrier with the PCB side facing down and the

connector end toward the rear of the carrier.

3. Allign the mounting holes in the drive with those in the carrier. Note that there

are holes in the carrier marked "SAS" or “SATA” to aid in correct installation.

4. Secure the drive to the carrier with four screws. Use the four M3 at-head

screws included in the HDD bag of your accessory box. Note that the screws

used to secure the dummy drive to the tray cannot be reused to secure the

hard drive.

1 2 ... 137 138 139 140 141 142 143 144

Sin comentarios

Supermicro SuperChassis 836BA-R1K28B Manual de usuario Pagina 142