Supermicro 5017C-LF Manual de usuario descargar pdf (Pagina 63)

Chapter 6: Advanced Chassis Setup

6-7

6-6 Power Supply

The 5017C-LF has a single 200 watt power supply. This power supply has the

capability of operating at a 100 or 240 input voltage. If the power supply unit fails,

the system will shut down and you will need to replace the power supply unit.

Replacing the Power Supply

Unplug all power leading to the chassis. 1.

Disconnect all wiring from the power supply.2.

Remove the four screws which secure the power supply to the chassis. The 3.

two front mounting screws are located on the front of the power supply. The

two rear mounting screws are accessed on the underside of the chassis

and extend upwards through the mounting holes to hold the power supply in

place. Set the screws aside for later use.

Remove the power supply from the chassis.4.

Align the mounting holes on the power supply with the mounting holes in the 5.

chassis and reattach the power supply to the chassis using the four screws

which were previously set aside

Connect the chassis wiring to the power supply. 6.

Finish by reconnecting the AC power cord and depressing the power button 7.

on the front of the system.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 91 92

Sin comentarios

Supermicro 5017C-LF Manual de usuario Pagina 63