Supermicro SuperServer 7048A-T Manual de usuario descargar pdf (Pagina 16)

2-2

SuperWorkstation 7048A-T User's Manual

Choosing a Setup Location

•Leave enough clearance in front of the rack to enable you to open the front door

completely (~25 inches) and approximately 30 inches of clearance in the back

of the rack to allow for sufcient airow and ease in servicing.

•This product is not suitable for use with visual display work place devices

acccording to §2 of the the German Ordinance for Work with Visual Display Units.

2-4 Warnings and Precautions

Rack Precautions

•Ensure that the leveling jacks on the bottom of the rack are fully extended to

the oor with the full weight of the rack resting on them.

•In single rack installation, stabilizers should be attached to the rack. In multiple

rack installations, the racks should be coupled together.

•Always make sure the rack is stable before extending the server from the rack.

•You should extend only one component at a time - extending two or more si-

multaneously may cause the rack to become unstable.

Server Precautions

•Review the electrical and general safety precautions in Chapter 4.

•Determine the placement of each component in the rack before you install the

rails.

•Install the heaviest server components on the bottom of the rack rst, and then

work up.

•Use a regulating uninterruptible power supply (UPS) to protect the server from

power surges, voltage spikes and to keep your system operating in case of a

power failure.

•Allow the hot plug SAS/SATA drives and power supply modules to cool before

touching them.

•Always keep the rack's front door and all panels and components on the servers

closed when not servicing to maintain proper cooling.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 123 124

Sin comentarios

Supermicro SuperServer 7048A-T Manual de usuario Pagina 16