Supermicro SuperServer 7048A-T Manual de usuario descargar pdf (Pagina 48)

5-2

SuperWorkstation 7048A-T User's Manual

Unpacking

The serverboard is shipped in antistatic packaging to avoid electrical static dis-

charge. When unpacking the board, make sure the person handling it is static

protected.

5-3 Connecting Cables

Now that the serverboard is installed, the next step is to connect the cables to the

board. These include the data (ribbon) cables for the peripherals and control panel

and the power cables.

Connecting Data Cables

The cables used to transfer data from the peripheral devices have been carefully

routed to prevent them from blocking the ow of cooling air that moves through

the system from front to back. If you need to disconnect any of these cables, you

should take care to keep them routed as they were originally after reconnecting

them (make sure the red wires connect to the pin 1 locations). See the layout in

Section 5-8 for connector locations.

Connecting Power Cables

The X10DAi has a 24-pin primary power supply connector (J24) for connection to

the ATX power supply. In addition, two 8-pin secondary power connectors (JPWR1

and JPWR2) must also be connected to your power supply. See Section 5-9 for

power connector pin denitions.

Connecting the Control Panel

JF1 contains header pins for various front control panel connectors. See Figure 5-1

for the pin locations of the various front control panel buttons and LED indicators.

All JF1 wires have been bundled into a single ribbon cable to simplify this connec-

tion. Make sure the red wire plugs into pin 1 as marked on the board. The other

end connects to the Control Panel PCB board, located just behind the system status

LEDs on the chassis. See Section 5-9 for details and pin descriptions.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 123 124

Sin comentarios

Supermicro SuperServer 7048A-T Manual de usuario Pagina 48