Supermicro SuperServer 7048A-T Manual de usuario descargar pdf (Pagina 75)

Chapter 6: Advanced Chassis Setup

6-3

6-2 Front Control Panel

The front control panel must be connected to the JF1 connector on the serverboard

to provide you with system status and alarm indications. A ribbon cable has bundled

these wires together to simplify this connection.

Connect the cable from JF1 on the serverboard (making sure the red wire plugs

into pin 1) to the appropriate comnnector on the front control panel PCB (printed

circuit board). Pull all excess cabling over to the control panel side of the chassis.

The LEDs on the control panel inform you of system status - see Figure 6-2 for

details. See Chapter 5 for details on JF1.

Figure 6-2. Front Control Panel LEDs

Power

NIC1

HDD

Overheat/Fan Fail

Indicates power is being supplied to the system.

Indicates network activity on LAN port 1.

On the 7048A-T, this LED indicates hard drive activity

when ashing.

When this LED ashes, it indicates a fan failure. When

on continuously it indicates an overheat condition (see

Chapter 3 for details).

NIC2

Indicates network activity on LAN port 2

Power Fail

Indicates a power supply fan failure. An alarm will also

sound, which can be turned off with the reset switch on

the back of the power supply.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 123 124

Sin comentarios

Supermicro SuperServer 7048A-T Manual de usuario Pagina 75