Supermicro SuperServer 7048A-T Manual de usuario descargar pdf (Pagina 67)

Chapter 5: Advanced Serverboard Setup

5-21

GLAN Enable/Disable

JPL1 enables/disables both LAN ports

1 and 2, while JPL2 enables/disables

LAN2 only. See the table on the right

for jumper settings. The default setting

is enabled.

LAN

Jumper Settings

Jumper Setting Denition

Pins 1-2 Enabled

Pins 2-3 Disabled

Watch Dog Enable/Disable

JWD controls the Watch Dog function.

Watch Dog is a system monitor that

can reboot the system when a software

application hangs. Jumping pins 1-2

will cause WD to reset the system if

an application hangs. Jumping pins 2-3

will generate a non-maskable interrupt

signal for the application that hangs.

See the table on the right for jumper

settings. Watch Dog must also be

enabled in BIOS.

Watch Dog

Jumper Settings

Jumper Setting Denition

Pins 1-2 Reset (default)

Pins 2-3 NMI

Open Disabled

LAN Enable/Disable

Jumpers

Jumpers LAN Ports Supported

JPL1 Enable/Disable LAN1 & LAN2

JPL2 Enable/Disable LAN2

ME Mode Select

Jumper Settings

Jumper Setting Denition

Pins 1-2 Manufacture Mode

Pins 2-3 Normal

Management Engine

Jumper JPME2 allows the user to ash

the system rmware from a host server

to modify system settings. Close this

jumper to bypass SPI ash security,

and force ME into recovery mode in or-

der to use recovery jumpers. See the

table on the right for jumper settings.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 123 124

Comentarios a estos manuales

Sin comentarios

Supermicro SuperServer 7048A-T Manual de usuario Pagina 67

Comentarios a estos manuales

Relacionado con productos y manuales para Barebones Servidor Supermicro SuperServer 7048A-T