Supermicro SuperServer 7048R-C1R4+ Manual de usuario Pagina 64
- Pagina / 132
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
5-18
SUPERSERVER 7048R-C1R(T)4+ User's Manual
GLAN/10G-LAN (TLAN) Ports & IPMI_LAN Port
Four Ethernet ports (LAN1/2, LAN3/4) are located on the I/O backplane on the
serverboard. These Ethernet ports support Gigabit LANs on the X10DRC-T4+ and
support 10G-LANs on the X10DRC-LN4+. In addition, an IPMI_LAN, located above
USB 0/1 ports, can be used for IPMI SOL (Serial-over LAN) support. All these ports
accept RJ45 type cables. Please refer to the LED Indicator Section for LAN LED
information.
GLAN/TLAN Ports
Pin Denition
Pin# Denition Pin# Denition
A1 TDR1+ A10 TDR4+
A3 TRCT1 A12 TRCT4
A2 TDR1- A11 TDR4-
A4 TDR2+- A13 IET+
A6 TRCT2 A14 IET-
A5 TDR2-- A15 YEL+
A7 TDR3+ A16 YEL-
A9 TRCT3 A17 ORG-/GRE+
A8 TDR3- A18 ORG+/GRE-
IPMI LAN Port
Pin Denition
Pin# Denition Pin# Denition
11 TX1- 20 YEL+
10 TX1+ 19 YEL-
13 TX2- 22 ORG-/GRN+
12 TX2+- 21 ORG+/GRN-
15 TX3- 23 SGND
14 TX3+ 24 SGND
17 TX4- 25 SGND
16 TX4+ 26 SGND
9 VCC
18 GND
Unit Identier Switch/UID LED
Indicator
A rear Unit Identier (UID) switch/
LED is located next to the VGA port
on the rear I/O shield. The front UID
is located on pin 13 on the Front
Panel Control (JF1), and the front
UID LED is located on pin 7 on JF1.
When you press the front or rear UID
switch, both front and rear UID LEDs
turn on. Press the UID switch again to
turn off the LED indicators. The UID
Indicators provide easy identication
of a system among many.
The UID can also be triggered using
IPMI
UID Switch
Pin# Denition
1 Ground
2 Ground
3+4 Button In
UID LED Status
Color/State Status
Blue: On Unit Identied
- SUPER 1
- Manual Revision 1.0 2
- Release Date: October 9, 2014 2
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 1 9
- Introduction 9
- 1-2 Serverboard Features 10
- 1-3 Server Chassis Features 11
- 1-4 Contacting Supermicro 13
- Chapter 2 15
- Server Installation 15
- 2-4 Warnings and Precautions 16
- Rack Mounting Considerations 17
- Inner rail 18
- Outer rail 18
- Rail brackets 18
- Installing the Chassis Rails 19
- Installing the Rack Rails 20
- Chapter 3 23
- System Interface 23
- 3-3 Control Panel LEDs 24
- 3-4 Drive Carrier LEDs 25
- Chapter 4 27
- Installation Instructions 30
- Circuit Breaker 31
- Power Disconnection Warning 32
- ילמשח קותינ ינפמ הרהזא 33
- Equipment Installation 34
- Restricted Area 35
- Battery Handling 36
- Redundant Power Supplies 38
- Backplane Voltage 39
- Product Disposal 41
- Hot Swap Fan Warning 42
- Power Cable and AC Adapter 44
- (UL/CSA ) 45
- Chapter 5 47
- Advanced Serverboard Setup 47
- OPEN 1st 48
- IMPORTANT! 49
- 5-3 Connecting Cables 52
- 5-4 I/O Ports 53
- 5-5 Installing Memory 54
- Memory Support 55
- INTEL CONFIDENTIAL 56
- TPM/PORT80 57
- Serverboard Quick Reference 58
- 5-7 Connector Denitions 60
- Front Control Panel 61
- Rear I/O Shield 63
- GLAN/TLAN Ports 64
- Pin Denition 64
- IPMI LAN Port 64
- UID LED Status 64
- Other Connectors 65
- 1-2 Enabled (default) 68
- 2-3 Disabled 68
- 5-9 Onboard Indicators 70
- 5-10 SATA/SAS Connections 72
- 5-11 Installing Software 73
- SuperDoctor® 5 74
- 5-12 Onboard Battery 75
- Chapter 6 77
- Advanced Chassis Setup 77
- 6-2 Front Control Panel 79
- 6-3 System Fans 80
- 6-4 Drive Bay Installation 82
- SAS/SATA Backplane 83
- Mobile Rack (Storage Module) 84
- Enclosure Release 85
- Mobile Rack 85
- Mobile Rack Enclosure 85
- 6-5 Power Supply 86
- Chapter 7 87
- 7-2 Main Setup 88
- Boot Feature 90
- Power Conguration 91
- CPU Conguration 92
- Chipset Conguration 96
- North Bridge 96
- IIO Conguration 96
- IIO1 Conguration 96
- IIO2 Conguration 97
- •Number of CPU 98
- •Number of II0 98
- •Current QPI Link Speed 98
- •Current QPI Link Frequency 99
- DIMM Information 100
- •USB Module Version 101
- •USB Devices 101
- SATA Conguration 103
- •PCI Bus Driver Version 108
- •PCI Device Common Settings 108
- Super IO Conguration 110
- ACPI Settings 117
- 7-4 Event Logs 118
- View SMBIOS Event Log 119
- 7-5 IPMI 120
- •IPMI LAN Selection 121
- •IPMI Network Link Status 121
- 7-6 Security Settings 122
- 7-7 Boot Settings 123
- •Legacy Boot Order #1 124
- •UEFI Boot Order #1 124
- 7-8 Save & Exit 125
- Appendix A 127
- BIOS Error Beep Codes 127
- Appendix B 129
- System Specications 129
- Power Supply 131
- Operating Environment 131
- Regulatory Compliance 131
Relacionado con productos y manuales para Barebones Servidor Supermicro SuperServer 7048R-C1R4+
Barebones Servidor Supermicro 5038D-I Manual de usuario
(114 paginas)
(114 paginas)
Barebones Servidor Supermicro 188411 Manual de usuario
(122 paginas)
(122 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.042 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales