Supermicro SuperServer 7048R-C1R4+ Manual de usuario Pagina 80
- Pagina / 132
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
6-4
SUPERSERVER 7048R-C1RT4+/7048R-C1R4+ User's Manual
6-3 System Fans
Three 8-cm chassis cooling fans (located in the center of the chassis) provide cool-
ing airow while two 8-cm exhaust fans expel hot air from the chassis. The chassis
is also tted with an air shroud to concentrate the ow of cooling air over the areas
of highest generated heat. The fans should all be connected to headers on the
serverboard (see Chapter 5). Each power supply module also has a cooling fan.
Fan Failure
Under normal operation, all three chassis fans, both exhaust fans and the
power supply fans run continuously. The chassis fans and the exhaust fans are
hot-swappable and can be replaced without powering down the system.
Accessing the Inside of the System
1. If rack mounted, rst release the screws that secure the unit to the rack.
2. Grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click").
3. There are two screws that secure the cover to the chassis - remove these
rst.
4. Locate the latch on the top (side if tower) of the chassis - depress where it
says "push" then lift the latch to release the cover.
5. Lift the cover from the chassis to gain full access to the inside of the server.
Replacing Chassis Cooling Fans
1. Depress the locking tab on the failed fan: on a chassis fan, push the tab on
the side of the housing inward, on the exhaust fan push down on the colored
tab. With the tab depressed, pull the unit straight out (see Figure 6-3). The
wiring for these fans has been designed to detach automatically.
2. Replace the failed fan with an identical one. Install it in the same position
and orientation as the one you removed; it should click into place when fully
inserted. Check that the fan is working then replace the top/left side chassis
panel.
- SUPER 1
- Manual Revision 1.0 2
- Release Date: October 9, 2014 2
- About This Manual 3
- Manual Organization 3
- Table of Contents 6
- Chapter 1 9
- Introduction 9
- 1-2 Serverboard Features 10
- 1-3 Server Chassis Features 11
- 1-4 Contacting Supermicro 13
- Chapter 2 15
- Server Installation 15
- 2-4 Warnings and Precautions 16
- Rack Mounting Considerations 17
- Inner rail 18
- Outer rail 18
- Rail brackets 18
- Installing the Chassis Rails 19
- Installing the Rack Rails 20
- Chapter 3 23
- System Interface 23
- 3-3 Control Panel LEDs 24
- 3-4 Drive Carrier LEDs 25
- Chapter 4 27
- Installation Instructions 30
- Circuit Breaker 31
- Power Disconnection Warning 32
- ילמשח קותינ ינפמ הרהזא 33
- Equipment Installation 34
- Restricted Area 35
- Battery Handling 36
- Redundant Power Supplies 38
- Backplane Voltage 39
- Product Disposal 41
- Hot Swap Fan Warning 42
- Power Cable and AC Adapter 44
- (UL/CSA ) 45
- Chapter 5 47
- Advanced Serverboard Setup 47
- OPEN 1st 48
- IMPORTANT! 49
- 5-3 Connecting Cables 52
- 5-4 I/O Ports 53
- 5-5 Installing Memory 54
- Memory Support 55
- INTEL CONFIDENTIAL 56
- TPM/PORT80 57
- Serverboard Quick Reference 58
- 5-7 Connector Denitions 60
- Front Control Panel 61
- Rear I/O Shield 63
- GLAN/TLAN Ports 64
- Pin Denition 64
- IPMI LAN Port 64
- UID LED Status 64
- Other Connectors 65
- 1-2 Enabled (default) 68
- 2-3 Disabled 68
- 5-9 Onboard Indicators 70
- 5-10 SATA/SAS Connections 72
- 5-11 Installing Software 73
- SuperDoctor® 5 74
- 5-12 Onboard Battery 75
- Chapter 6 77
- Advanced Chassis Setup 77
- 6-2 Front Control Panel 79
- 6-3 System Fans 80
- 6-4 Drive Bay Installation 82
- SAS/SATA Backplane 83
- Mobile Rack (Storage Module) 84
- Enclosure Release 85
- Mobile Rack 85
- Mobile Rack Enclosure 85
- 6-5 Power Supply 86
- Chapter 7 87
- 7-2 Main Setup 88
- Boot Feature 90
- Power Conguration 91
- CPU Conguration 92
- Chipset Conguration 96
- North Bridge 96
- IIO Conguration 96
- IIO1 Conguration 96
- IIO2 Conguration 97
- •Number of CPU 98
- •Number of II0 98
- •Current QPI Link Speed 98
- •Current QPI Link Frequency 99
- DIMM Information 100
- •USB Module Version 101
- •USB Devices 101
- SATA Conguration 103
- •PCI Bus Driver Version 108
- •PCI Device Common Settings 108
- Super IO Conguration 110
- ACPI Settings 117
- 7-4 Event Logs 118
- View SMBIOS Event Log 119
- 7-5 IPMI 120
- •IPMI LAN Selection 121
- •IPMI Network Link Status 121
- 7-6 Security Settings 122
- 7-7 Boot Settings 123
- •Legacy Boot Order #1 124
- •UEFI Boot Order #1 124
- 7-8 Save & Exit 125
- Appendix A 127
- BIOS Error Beep Codes 127
- Appendix B 129
- System Specications 129
- Power Supply 131
- Operating Environment 131
- Regulatory Compliance 131
Relacionado con productos y manuales para Barebones Servidor Supermicro SuperServer 7048R-C1R4+
Barebones Servidor Supermicro 5038D-I Manual de usuario
(114 paginas)
(114 paginas)
Barebones Servidor Supermicro 188411 Manual de usuario
(122 paginas)
(122 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.084 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales