
1-2
SUPERSERVER 8047R-TRF+/7RFT+ USER'S MANUAL
• If you have any questions, please contact our support team at support@
supermicro.com
1-2 Serverboard Features
At the heart of the SuperServer 8047R-TRF+/7RFT+ lies the X9QRi-F+/X9QR7-TF+,
a dual processor serverboard based on the Intel C602 chipset. Below are the main
features of the X9QRi-F+/X9QR7-TF+. (See Figure 1-1 for a block diagram of the
chipset).
Processors
The X9QRi-F+/X9QR7-TF+ supports E5-4600 Series processors in
Socket R-LGA 2011 type sockets. Each processor supports two full-width Intel
QuickPath Interconnect (QPI) links (Data Transfer Rate of up to 8.0 GT/s per
direction) Please refer to our web site for a complete listing of supported processors
(www.supermicro.com).
Memory
The X9QRi-F+/X9QR7-TF+ has thirty-two (32) single/dual/
tri/quad channel 240-pin DIMM sockets that can support up to 1024GB
of Registered (RDIMM), Load Reduced (LRDIMM) ECC or Unbuffered
(UDIMM) ECC/Non-ECC DDR3 1600/1333/1066/800 MHz speed
SDRAM in a two-channel memory bus. Memory sizes of
1GB, 2GB, 4GB, 8GB, 16GB and 32GB size @ 1.35V/1.5V voltages are
supported. Please refer to Chapter 5 for installing memory.
Note: LRDIMM (Reduced Load) memory supports only
DDR3 1333/1066/800 MHz speeds.
Serial ATA
An on-chip (Intel C602) SATA controller is integrated into the X9QRi-F+/X9QR7-TF+
to provide a six-port SATA subsystem (two SATA 3.0 and four SATA 2.0 ports),
which is either RAID 0 and 1 (SATA3) or RAID 0, 1, 5, and 10 (SATA2) Windows/
LINUX supported. The SATA drives are hot-swappable units.
Note: You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.
Comentarios a estos manuales