Supermicro SuperServer 8047R-TRF+ Manual de usuario descargar pdf (Pagina 22)

2-4

SUPERSERVER 8047R-TRF+/7RFT+ USER'S MANUAL

2-5 Installing the System into a Rack

This section provides information on installing the SC748 chassis into a rack unit

with the rails provided. There are a variety of rack units on the market, which

may mean the assembly procedure will differ slightly. You should also refer to the

installation instructions that came with the rack unit you are using.

NOTE: The outer rail is adjustable from 26" to 38.25".

Removing the Feet

The SC748 chassis is shipped with the chassis cover and feet pre-installed. Both

the feet and cover must be removed for before installing the rails (see Figure 2-1).

Removing the Chassis Top Cover

1. Locate the chassis cover lock (blue lever) at the rear of the chassis cover.

2. Slide the chassis cover lock to the right and push chassis cover forward.

3. Lift the chassis top cover off the chassis.

Removing the Chassis Feet

1. Place the chassis on its side with the chassis side cover facing upward.

2. Remove the screw holding the chassis foot in place.

3. The foot lock is a tab located in the center of the foot that prevents the foot

from sliding. Using a ﬂ at head screwdriver, gently lift the foot lock upward

and slide the foot toward the rear of the chassis.

4. Repeat steps 2 and 3 with each remaining foot.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 121 122

Sin comentarios

Supermicro SuperServer 8047R-TRF+ Manual de usuario Pagina 22