Supermicro SYS-6015V-TB Manual de usuario descargar pdf (Pagina 47)

Chapter 5: Advanced Serverboard Setup

5-13

Overheat/Fan Fail LED

Connect an LED to pins 7 and 8 of JF1

to provide advanced warning of chas-

sis overheating. Refer to the table on

the right for pin deﬁ nitions.

NIC1 LED

The NIC1 (Network Interface Control-

ler) LED connection is located on pins

11 and 12 of JF1. Attach the NIC1

LED cable to display network activity.

Refer to the table on the right for pin

deﬁ nitions.

Power Fail LED

The Power Fail LED connection is

located on pins 5 and 6 of JF1. Refer

to the table on the right for pin deﬁ ni-

tions. This only applies to redundant

power supplies and so does not apply

to the 6015V-T/6015V-TLP.

NIC2 LED

The NIC2 (Network Interface Control-

ler) LED connection is located on pins

9 and 10 of JF1. Attach the NIC2

LED cable to display network activity.

Refer to the table on the right for pin

deﬁ nitions.

OH/Fan Fail LED

Pin Deﬁ nitions (JF1)

Pin# Deﬁ nition

7 Vcc

8 HD Active

Power Fail LED

Pin Deﬁ nitions (JF1)

Pin# Deﬁ nition

5 Vcc

6 Ground

NIC1 LED

Pin Deﬁ nitions (JF1)

Pin# Deﬁ nition

11 Vcc

12 Ground

NIC2 LED

Pin Deﬁ nitions (JF1)

Pin# Deﬁ nition

9 Vcc

10 Ground

HDD LED

The HDD (IDE Hard Disk Drive) LED

connection is located on pins 13 and

14 of JF1. Attach the IDE hard drive

LED cable to display disk activity.

Refer to the table on the right for pin

deﬁ nitions.

HDD LED

Pin Deﬁ nitions (JF1)

Pin# Deﬁ nition

13 Vcc

14 HD Active

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 121 122

Comentarios a estos manuales

Sin comentarios