Supermicro SYS-6015V-TB Manual de usuario descargar pdf (Pagina 53)

Chapter 5: Advanced Serverboard Setup

5-19

LAN1/2 Enable/Disable

Change the setting of jumper JPL1

and JPL2 to enable or disable the

LAN1 and LAN2 Gb Ethernet ports,

respectively. See the table on the

right for jumper settings. The default

setting is enabled

LAN1/2 Enable/Disable

Jumper Settings (JPL1/JPL2)

Jumper Setting Deﬁ nition

Pins 1-2 Enabled

Pins 2-3 Disabled

PCI Slots to SMB

Jumpers JI

2

C1 and JI

2

C2 allow you to

connect or disconnect the PCI slots to

the System Management Bus. The de-

fault setting is pins 2-3 for both jumpers

to disable the connection. Both con-

nectors must be set the same (one is

for data and one is for clock). See the

table on right for jumper settings.

PCI Slots to SMB Jumper

Settings (JI

2

C1, JI

2

C2)

Jumper Setting Deﬁ nition

Open Disabled

Closed Enabled

PWR Supply Failure Detect

The system can notify you in the event

of a power supply failure. This feature

is available when three power supply

units are installed in the chassis with one

acting as a backup. This jumper should

remain disabled on the 6015V-T/6015V-

TLP to prevent false alarms.

PWR Supply Failure Detect

Jumper Settings (JPWF)

Jumper Setting Deﬁ nition

Closed Enabled

Open Disabled

Power Force On Enable/

Disable

Jumper JPF allows you to enable or

disable the Power Force-On function.

If enabled, the power will always stay

on automatically. If this function is

disabled (the normal setting), the user

needs to press the power button to

power on the system.

Power Force On

Enable/Disable

Jumper Settings (JPF)

Jumper Setting Deﬁ nition

Open Normal

Closed Force On

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 121 122

Comentarios a estos manuales

Sin comentarios