Supermicro SYS-8016B-6F Manual de usuario descargar pdf (Pagina 67)

Chapter 6: Advanced Chassis Setup

6-9

6-5 Power Supply

The SuperServer 8016B-6F/8016B-TF has a single 1400 watt power supply, which

is auto-switching capable. This enables it to automatically sense and operate at a

100v to 240v input voltage. An amber light will be illuminated on the power supply

when the power is off. An illuminated green light indicates that the power supply

is operating.

Power Supply Failure

If the power supply unit fails, the system will shut down and you will need to replace

the unit. Replacement units can be ordered directly from Supermicro (see contact

information in the Preface). As there is only one power supply unit in the 8016B-

6F/8016B-TF, power must be completely removed from the server before removing

and replacing the power supply unit for whatever reason.

Removing the Power Supply

First unplug the power cord from the failed power supply module. The power supply

module is cold-swappable. To remove the failed power module, simply push the

release tab (on the back of the power supply) to the side and then pull the module

straight out (see Figure 6-6). The power supply wiring was designed to detach

automatically when the module is pulled from the chassis.

Installing a new Power Supply

Replace the failed power module with another PWS-1K01-1R power supply module.

Push the new power supply module into the power bay until you hear a click. Finish

by plugging the AC power cord back into the module and powering up the system

by depressing the power on/off button.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 105 106

Sin comentarios

Supermicro SYS-8016B-6F Manual de usuario Pagina 67