
7-39
Chapter 7: 1/10-Gb Ethernet Switch Firmware
SNMP Trap Settings
Clicking the TRAP MANAGER tab brings up the SNMP TRAP SETTINGS page (Figure 7-33),
which configures the set of management targets that must receive notifications. The
parameters for this page are shown in Table 7-23.
Table 7-22. SNMP Security Settings Page Parameters
Parameter Description
User Name USER NAME is the (User-based Security) model dependent security ID.
Authentication Protocol The AUTHENTICATION PROTOCOL is used for authentication.
Authentication Key
The A
UTHENTICATION KEY is the secret authentication key used for
messages sent on behalf of this user to/from the SNMP.
Privacy Protocol
PRIVACY PROTOCOL is an indication of whether or not messages sent on
behalf of this user to/from the SNMP are protected from disclosure, and if
so, the type of privacy protocol that is used.
Privacy Key
P
RIVACY KEY is an indication of whether or not messages sent on behalf of
this user to/from the SNMP are protected from disclosure.
Storage Type STORAGE TYPE can be configured as Volatile or Non-Volatile.
Figure 7-33. SNMP Trap Settings Page
Comentarios a estos manuales