
7-131
Chapter 7: 1/10-Gb Ethernet Switch Firmware
OSPF
The OSPF link allows you to configure the OSPF protocol through the following pages:
• "OSPF Basic Settings" on page 7-131
• "Area" on page 7-132
• "Interface" on page 7-133
• "Virtual Interface" on page 7-134
• "OSPF Neighbor" on page 7-135
• "OSPF RRD Route Configuration" on page 7-136
• "OSPF Area Aggregation" on page 7-137
• "External Aggregation" on page 7-138
OSPF Basic Settings
Clicking the BASIC SETTINGS tab brings up the OSPF BASIC SETTINGS page
(Figure 7-116). The parameters for this page are shown in Table 7-90.
Figure 7-116. OSPF Basic Settings Page
Table 7-90. OSPF Basic Settings Page Parameters
Parameter Description
OSPF Status This parameter specifies the global status of the protocol in the switch.
Router ID This parameter specifies the router identifier.
Comentarios a estos manuales