
7-97
Chapter 7: 1/10-Gb Ethernet Switch Firmware
Port Settings
Clicking the PORT SETTINGS tab brings up the LA PORT SETTINGS page (Figure 7-84),
which configures LA properties at a per-port level. The parameters for this page are
shown in Table 7-62.
Figure 7-84. LA Port Settings Page
Table 7-62. LA Port Settings Page Parameters
Parameter Description
Port This parameter specifies the Interface Index.
Port Priority This parameter specifies the priority value of the Port.
Mode
This parameter specifies the various port modes, such as LACP, Manual or
Disable.
Activity
This parameter specifies whether the Port LACP activity is Active or
Passive.
Timeout
This parameter sets the time within which LACP PDUs must be received
on a port to avoid timing out of the Aggregated Link. If a Long timeout is
chosen then the ports will time out of the Port Channel in 90-seconds. If a
Short timeout is chosen then the ports will time out of the Port Channel in
3-seconds.
Comentarios a estos manuales