Supermicro AOC-XEH-IN2 Manual de usuario descargar pdf (Pagina 83)

6-19

Chapter 6: 1-Gb Ethernet Switch Firmware

To configure storm control, click STORM CONTROL link in the RATE LIMIT AND STORM

ONTROL screen (Figure 6-14). The STORM CONTROL screen appears as shown in

Figure 6-15.

6-9 L2 Management

L2 management provides a way to add, delete, and look up MAC addresses in the L2

address table. The switch supports 8192 L2 address table entries, each specifying a

MAC address, VLAN ID, destination port number, trunk ID and Rtag. The switch

supports store-and-forward mode switching.

After a frame is received, its source MAC address (MACSA) and destination MAC

address (MACDA) are retrieved. Depending on the port state, the MACSA and port

number may be used to dynamically update the L2 address table. The MACDA may be

used to determine the frame’s destination port. User can also statically add a MAC

address to the L2 address table.

To add a static entry into the L2

ADDRESS table, click on the ADD link on the L2 ADDRESS

ANAGEMENT screen as shown in Figure 6-16.

Figure 6-15. Storm Control Screen

Table 6-6. Storm Control Screen Controls

Control Description

Storm Control Type

This selects the type of the packet storm. The figure below shows all available

options: Broadcast only, Broadcast and multicast, Broadcast unknown unicast

and Broadcast, multicast, and unknown unicast.

Storm Control Rate

This selects a rate (packets-per-second) for storm control. The figure below

shows all available options: 10 pps 100 pps 1000 pps 5000 pps 10000 pps and

15000 pps.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 391 392

Sin comentarios

Supermicro AOC-XEH-IN2 Manual de usuario Pagina 83