Supermicro AOC-XEH-IN2 Manual de usuario descargar pdf (Pagina 52)

Superblade Network Modules User’s Manual

4-6

4-5 SBM-IBP-D14 InfiniBand Pass-Through Module

The SBM-IBP-D14 InfniBand Pass-through Module is a triple-wide non-configurable

pass-through module that includes fourteen (14) 4X DDR copper ports with CX-4

connectors. The pass-through module is used to provide a connection between the

Infiniband controller (Add-on Card) mounted on the blade’s mainboard and an external

InfiniBand device.

Unlike the SBM-IBS-001 4x DDR InfiniBand switch module, this is a pass-through

module. With this module Blade 1 would be connected directly to port 1, Blade 2 to port

2 and so on. If you are only connected to 10 blades then ports 11 through 14 are not

connected.

Temperature and voltage of the pass-through module are read through the CMM

module. Like other SuperBlade network modules, this pass-through module is

hot-pluggable.

4-6 Installation and Configuration of InfiniBand Switch

Modules

This section covers the installation, removal and configuration of InfiniBand switch

modules and InfiniBand pass-through modules.

Installing/Removing the InfiniBand Switch Module

Before installing the InfiniBand switch module make sure the cover to the module has

been installed before proceeding. Refer to the anti-static precautions described in

Chapter 2.

The InifiniBand switch module must be installed into a double-wide bay. Assuming that

you have already created a double-wide bay out of two single-wide bays, continue with

the steps below. See the SuperBlade User’s Manual for details on setting up

double-wide bays in the SuperBlade enclosure.

Figure 4-4. SBM-IBP-D14 InfiniBand Pass-Through Triple-Wide Module

NOTE: The SBM-IBP-D14 InfniBand Pass-through Module must be connected

to another InfiniBand module in order to operate.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 391 392

Sin comentarios

Supermicro AOC-XEH-IN2 Manual de usuario Pagina 52