Supermicro Superblade SBM-GEM-002 Gigabit Ethernet module Manual de usuario Pagina 126

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 334
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 125
Superblade Network Modules User’s Manual
40
QoS
Clicking on the QOS link of the SYSTEM page allows you to configure QoS through
following control tabs:
Basic Settings
•Classmap
Policymap
COSQ Algorithm
Cosq Traffic Class
By default, the B
ASIC SETTINGS tab is loaded.
Ports List (Incoming) Specifies the Incoming Port List for which the filter has to be applied.
Ports List (Outgoing) Specifies the Outgoing Port List for which the filter has to be applied.
Protocol Specifies the type of protocol.
Message Code
Specifies the Message Code to be checked for ICMP Packets. (This is
enabled only if ICMP is chosen.)
Message Type
Specifies the Message Type to be checked for ICMP Packets. (This is
enabled only if ICMP is chosen.)
Priority Specifies the Priority for the filter.
TOS Specifies the Type of Service for the access list.
ACK Bit
Indicates the TCP Ack Bit to be checked against the incoming packet.
(This is enabled only if TCP is chosen.)
RST Bit
Indicates the TCP Reset Bit to be checked against the incoming packet.
(This is enabled only if TCP is chosen.)
Source Port (Min)
Specifies the TCP/UDP source port from which the access list has to be
applied.
Source Port (Max)
Specifies the TCP/UDP source ports to which the access list has to be
applied.
Destination Port (Min)
Specifies the TCP/UDP destination port from which the access list has to
be applied.
Destination Port (Max)
Specifies the TCP/UDP destination port to which the access list has to be
applied.
Table 7-23. IP Extended ACL Configuration Page Parameters (Continued)
Parameter Description
Vista de pagina 125
1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 333 334

Comentarios a estos manuales

Sin comentarios