
161
Chapter 7: 10-Gb Ethernet Switch Firmware
VRRP
The VRRP link allows you to configure VRRP through the following two control tabs:
• Basic Settings
• VRRP Settings
By default, the B
ASIC SETTINGS tab is loaded.
Basic Settings
Clicking on the BASIC SETTINGS tab opens the VRRP BASIC SETTINGS page
(Figure 7-126), which allows you to configure the VRRP Status. The only parameter on
this page is VRRP Status, which specifies the status of VRRP in the switch.
Figure 7-126. VRRP Basic Settings Page
Comentarios a estos manuales