
151
Chapter 7: 10-Gb Ethernet Switch Firmware
Clicking on the FILTERS tab opens the BGP FILTER CONFIGURATION page (Figure 7-117).
This page is used to set filters on routes being learnt. Table 7-94 lists the parameters
found on this page.
Table 7-94. BGP Filter Configuration Page Parameters
Parameter Description
Filter ID Specifies the filter index.
Remote AS
Specifies the remote AS associated with the BGP peer from which the
router is being distributed.
IP Address Specifies the IP address for which the route is being learnt.
IP Address Prefix Length Specifies the prefix length to calculate the Subnet.
Intermediate AS Represents the intermediate AS between the BGP peers.
Direction Indicates the direction of the packet.
Action Allows/denies the filtering for the above set of configuration.
Status Specifies the status of the entry.
Comentarios a estos manuales