
67
Chapter 7: 10-Gb Ethernet Switch Firmware
Basic Settings
Clicking on the BASIC SETTINGS tab brings up the RSTP CONFIGURATION page
(Figure 7-56). Table 7-37 lists the parameters found on this page.
Table 7-36. RSTP Global Configuration Page Parameters
Parameter Description
Context ID Specifies the context ID.
System Control Starts or Shutsdown RSTP in switch.
Status Allows you to Enable/Disable the protocol at a global level on the switch.
Dynamic Path Cost
Calculation
Permits to determine whether dynamic path cost calculation is allowed or
not.
Figure 7-56. RSTP Configuration Page
Comentarios a estos manuales