
183
Chapter 7: 10-Gb Ethernet Switch Firmware
Candidate RP
Clicking on the CANDIDATE RP tab (Rendezvous Point) opens the CANDIDATE RP
C
ONFIGURATION page (Figure 7-144). Table 7-118 lists the parameters found on this
page.
Figure 7-144. Candidate RP Configuration Page
Table 7-118. Candidate RP Configuration Page Parameters
Parameter Description
Component Id Specifies a number uniquely identifying the component.
Group Address
Represents the multicast group, for which the switch advertises itself as
the candidate RP.
Group Mask
Specifies the subnet mask, which when combined with the group address
gives the group prefix.
RP Address Represents the IP address of the Candidate-RP.
Comentarios a estos manuales