Supermicro Superblade SBM-GEM-002 Gigabit Ethernet module Manual de usuario descargar pdf (Pagina 36)

Superblade Network Modules User’s Manual

Command Line

Configuring the switch can be done using a command line via telnet or by using the

serial console interface.

Accessing CLI through Telnet:

To access command line via telnet, follow the below steps.

1. Connect a PC to a network that is accessible to the switch.

For example, connect a PC to any of the front panel ports of the switch and make

sure the PC has an IP address on the same subnet as the switch management IP.

2. In the PC, start a telnet client session with the switch management IP (default IP is

192.168.100.102).

This brings up the switch’s command line interface for user login.

3. Enter username and password to login to the switch.

4. To view the switch configurations use show commands and to configure the switch

type config term to get access to the configuration commands. For help type ? or

help.

Accessing CLI through a Serial Console

To access command line via a serial console, follow the below steps.

1. Connect a PC serial port to the switch console port.

2. In the PC, open any seral port access applications, such as Hyperterminal or Term

Ter m.

3. Choose the serial port connected with the switch and configure with the following

parameters:

Baudrate = 9600

Data bits = 8

Parity = None

Stop bit = 1

4. This brings up the switch’s command line interface for user login.

5. Enter username and password to login to the switch.

6. To view the switch configurations use show commands and to configure the switch

type config term to get access to the configuration commands. For help type ? or

help.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 333 334

Sin comentarios

Supermicro Superblade SBM-GEM-002 Gigabit Ethernet module Manual de usuario Pagina 36